2.4.1. Digital TV frontend open()

2.4.1.1. Name

fe-open - Open a frontend device

2.4.1.2. Synopsis

#include <fcntl.h>
int open(const char *device_name, int flags)

2.4.1.3. Arguments

device_name
Device to be opened.
flags

Open flags. Access can either be O_RDWR or O_RDONLY.

Multiple opens are allowed with O_RDONLY. In this mode, only query and read ioctls are allowed.

Only one open is allowed in O_RDWR. In this mode, all ioctls are allowed.

When the O_NONBLOCK flag is given, the system calls may return EAGAIN error code when no data is available or when the device driver is temporarily busy.

Other flags have no effect.

2.4.1.4. Description

This system call opens a named frontend device (/dev/dvb/adapter?/frontend?) for subsequent use. Usually the first thing to do after a successful open is to find out the frontend type with ioctl FE_GET_INFO.

The device can be opened in read-only mode, which only allows monitoring of device status and statistics, or read/write mode, which allows any kind of use (e.g. performing tuning operations.)

In a system with multiple front-ends, it is usually the case that multiple devices cannot be open in read/write mode simultaneously. As long as a front-end device is opened in read/write mode, other open() calls in read/write mode will either fail or block, depending on whether non-blocking or blocking mode was specified. A front-end device opened in blocking mode can later be put into non-blocking mode (and vice versa) using the F_SETFL command of the fcntl system call. This is a standard system call, documented in the Linux manual page for fcntl. When an open() call has succeeded, the device will be ready for use in the specified mode. This implies that the corresponding hardware is powered up, and that other front-ends may have been powered down to make that possible.

2.4.1.5. Return Value

On success open() returns the new file descriptor. On error, -1 is returned, and the errno variable is set appropriately.

Possible error codes are:

On success 0 is returned, and ca_slot_info is filled.

On error -1 is returned, and the errno variable is set appropriately.

EPERM The caller has no permission to access the device.
EBUSY The the device driver is already in use.
EMFILE The process already has the maximum number of files open.
ENFILE The limit on the total number of files open on the system has been reached.

The generic error codes are described at the Generic Error Codes chapter.