25.5. Fake NUMA For CPUSets¶
David Rientjes <email@example.com>
Using numa=fake and CPUSets for Resource Management
This document describes how the numa=fake x86_64 command-line option can be used in conjunction with cpusets for coarse memory management. Using this feature, you can create fake NUMA nodes that represent contiguous chunks of memory and assign them to cpusets and their attached tasks. This is a way of limiting the amount of system memory that are available to a certain class of tasks.
For more information on the features of cpusets, see CPUSETS. There are a number of different configurations you can use for your needs. For more information on the numa=fake command line option and its various ways of configuring fake nodes, see AMD64 Specific Boot Options.
For the purposes of this introduction, we’ll assume a very primitive NUMA emulation setup of “numa=fake=4*512,”. This will split our system memory into four equal chunks of 512M each that we can now use to assign to cpusets. As you become more familiar with using this combination for resource control, you’ll determine a better setup to minimize the number of nodes you have to deal with.
A machine may be split as follows with “numa=fake=4*512,” as reported by dmesg:
Faking node 0 at 0000000000000000-0000000020000000 (512MB) Faking node 1 at 0000000020000000-0000000040000000 (512MB) Faking node 2 at 0000000040000000-0000000060000000 (512MB) Faking node 3 at 0000000060000000-0000000080000000 (512MB) ... On node 0 totalpages: 130975 On node 1 totalpages: 131072 On node 2 totalpages: 131072 On node 3 totalpages: 131072
Now following the instructions for mounting the cpusets filesystem from CPUSETS, you can assign fake nodes (i.e. contiguous memory address spaces) to individual cpusets:
[root@xroads /]# mkdir exampleset [root@xroads /]# mount -t cpuset none exampleset [root@xroads /]# mkdir exampleset/ddset [root@xroads /]# cd exampleset/ddset [root@xroads /exampleset/ddset]# echo 0-1 > cpus [root@xroads /exampleset/ddset]# echo 0-1 > mems
Now this cpuset, ‘ddset’, will only allowed access to fake nodes 0 and 1 for memory allocations (1G).
You can now assign tasks to these cpusets to limit the memory resources available to them according to the fake nodes assigned as mems:
[root@xroads /exampleset/ddset]# echo $$ > tasks [root@xroads /exampleset/ddset]# dd if=/dev/zero of=tmp bs=1024 count=1G  13425
Notice the difference between the system memory usage as reported by /proc/meminfo between the restricted cpuset case above and the unrestricted case (i.e. running the same ‘dd’ command without assigning it to a fake NUMA cpuset):
This allows for coarse memory management for the tasks you assign to particular cpusets. Since cpusets can form a hierarchy, you can create some pretty interesting combinations of use-cases for various classes of tasks for your memory management needs.