Kernel driver ltc4261¶
Linear Technology LTC4261
Addresses scanned: -
Author: Guenter Roeck <firstname.lastname@example.org>
The LTC4261/LTC4261-2 negative voltage Hot Swap controllers allow a board to be safely inserted and removed from a live backplane.
This driver does not probe for LTC4261 devices, since there is no register which can be safely used to identify the chip. You will have to instantiate the devices explicitly.
Example: the following will load the driver for an LTC4261 at address 0x10 on I2C bus #1:
$ modprobe ltc4261 $ echo ltc4261 0x10 > /sys/bus/i2c/devices/i2c-1/new_device
Voltage readings provided by this driver are reported as obtained from the ADC registers. If a set of voltage divider resistors is installed, calculate the real voltage by multiplying the reported value with (R1+R2)/R2, where R1 is the value of the divider resistor against the measured voltage and R2 is the value of the divider resistor against Ground.
Current reading provided by this driver is reported as obtained from the ADC Current Sense register. The reported value assumes that a 1 mOhm sense resistor is installed. If a different sense resistor is installed, calculate the real current by dividing the reported value by the sense resistor value in mOhm.
The chip has two voltage sensors, but only one set of voltage alarm status bits. In many many designs, those alarms are associated with the ADIN2 sensor, due to the proximity of the ADIN2 pin to the OV pin. ADIN2 is, however, not available on all chip variants. To ensure that the alarm condition is reported to the user, report it with both voltage sensors.
|in1_input||ADIN2 voltage (mV)|
|in1_min_alarm||ADIN/ADIN2 Undervoltage alarm|
|in1_max_alarm||ADIN/ADIN2 Overvoltage alarm|
|in2_input||ADIN voltage (mV)|
|in2_min_alarm||ADIN/ADIN2 Undervoltage alarm|
|in2_max_alarm||ADIN/ADIN2 Overvoltage alarm|
|curr1_input||SENSE current (mA)|
|curr1_alarm||SENSE overcurrent alarm|