Kernel driver ltc4151¶
Linear Technology LTC4151
Addresses scanned: -
Author: Per Dalen <firstname.lastname@example.org>
The LTC4151 is a High Voltage I2C Current and Voltage Monitor.
This driver does not probe for LTC4151 devices, since there is no register which can be safely used to identify the chip. You will have to instantiate the devices explicitly.
Example: the following will load the driver for an LTC4151 at address 0x6f on I2C bus #0:
# modprobe ltc4151 # echo ltc4151 0x6f > /sys/bus/i2c/devices/i2c-0/new_device
Voltage readings provided by this driver are reported as obtained from the ADIN and VIN registers.
Current reading provided by this driver is reported as obtained from the Current Sense register. The reported value assumes that a 1 mOhm sense resistor is installed.
|in1_input||VDIN voltage (mV)|
|in2_input||ADIN voltage (mV)|
|curr1_input||SENSE current (mA)|