Bare UDP Tunnelling Module Documentation

There are various L3 encapsulation standards using UDP being discussed to leverage the UDP based load balancing capability of different networks. MPLSoUDP (__ https://tools.ietf.org/html/rfc7510) is one among them.

The Bareudp tunnel module provides a generic L3 encapsulation support for tunnelling different L3 protocols like MPLS, IP, NSH etc. inside a UDP tunnel.

Special Handling

The bareudp device supports special handling for MPLS & IP as they can have multiple ethertypes. MPLS procotcol can have ethertypes ETH_P_MPLS_UC (unicast) & ETH_P_MPLS_MC (multicast). IP protocol can have ethertypes ETH_P_IP (v4) & ETH_P_IPV6 (v6). This special handling can be enabled only for ethertypes ETH_P_IP & ETH_P_MPLS_UC with a flag called multiproto mode.

Usage

  1. Device creation & deletion

    1. ip link add dev bareudp0 type bareudp dstport 6635 ethertype mpls_uc

      This creates a bareudp tunnel device which tunnels L3 traffic with ethertype 0x8847 (MPLS traffic). The destination port of the UDP header will be set to 6635.The device will listen on UDP port 6635 to receive traffic.

    2. ip link delete bareudp0

  2. Device creation with multiproto mode enabled

The multiproto mode allows bareudp tunnels to handle several protocols of the same family. It is currently only available for IP and MPLS. This mode has to be enabled explicitly with the “multiproto” flag.

  1. ip link add dev bareudp0 type bareudp dstport 6635 ethertype ipv4 multiproto

    For an IPv4 tunnel the multiproto mode allows the tunnel to also handle IPv6.

  2. ip link add dev bareudp0 type bareudp dstport 6635 ethertype mpls_uc multiproto

    For MPLS, the multiproto mode allows the tunnel to handle both unicast and multicast MPLS packets.

  1. Device Usage

The bareudp device could be used along with OVS or flower filter in TC. The OVS or TC flower layer must set the tunnel information in SKB dst field before sending packet buffer to the bareudp device for transmission. On reception the bareudp device extracts and stores the tunnel information in SKB dst field before passing the packet buffer to the network stack.