6.13. ioctl MEDIA_REQUEST_IOC_QUEUE

6.13.1. Name

MEDIA_REQUEST_IOC_QUEUE - Queue a request

6.13.2. Synopsis

int ioctl(int request_fd, MEDIA_REQUEST_IOC_QUEUE)

6.13.3. Arguments

request_fd
File descriptor returned by ioctl MEDIA_IOC_REQUEST_ALLOC.

6.13.4. Description

If the media device supports requests, then this request ioctl can be used to queue a previously allocated request.

If the request was successfully queued, then the file descriptor can be polled to wait for the request to complete.

If the request was already queued before, then EBUSY is returned. Other errors can be returned if the contents of the request contained invalid or inconsistent data, see the next section for a list of common error codes. On error both the request and driver state are unchanged.

Once a request is queued, then the driver is required to gracefully handle errors that occur when the request is applied to the hardware. The exception is the EIO error which signals a fatal error that requires the application to stop streaming to reset the hardware state.

It is not allowed to mix queuing requests with queuing buffers directly (without a request). EBUSY will be returned if the first buffer was queued directly and you next try to queue a request, or vice versa.

A request must contain at least one buffer, otherwise this ioctl will return an ENOENT error.

6.13.5. Return Value

On success 0 is returned, on error -1 and the errno variable is set appropriately. The generic error codes are described at the Generic Error Codes chapter.

EBUSY
The request was already queued or the application queued the first buffer directly, but later attempted to use a request. It is not permitted to mix the two APIs.
ENOENT
The request did not contain any buffers. All requests are required to have at least one buffer. This can also be returned if some required configuration is missing in the request.
ENOMEM
Out of memory when allocating internal data structures for this request.
EINVAL
The request has invalid data.
EIO
The hardware is in a bad state. To recover, the application needs to stop streaming to reset the hardware state and then try to restart streaming.