Linux I2O Support	(c) Copyright 1999 Red Hat Software
					and others.

	This program is free software; you can redistribute it and/or
	modify it under the terms of the GNU General Public License
	as published by the Free Software Foundation; either version
	2 of the License, or (at your option) any later version.

AUTHORS (so far)

Alan Cox, Building Number Three Ltd.
	Core code, SCSI and Block OSMs

Steve Ralston, LSI Logic Corp.
	Debugging SCSI and Block OSM

Deepak Saxena, Intel Corp.
	Various core/block extensions
	/proc interface, bug fixes
	Ioctl interfaces for control
	Debugging LAN OSM

Philip Rumpf
	Fixed assorted dumb SMP locking bugs

Juha Sievanen, University of Helsinki Finland
	LAN OSM code
	/proc interface to LAN class
	Bug fixes
	Core code extensions

Auvo H�kkinen, University of Helsinki Finland
	LAN OSM code
	/Proc interface to LAN class
	Bug fixes
	Core code extensions

Taneli V�h�kangas, University of Helsinki Finland
	Fixes to i2o_config

Boji T Kannanthanam
	Intel i2o controller work, extending proc/config stuff

CREDITS

	This work was made possible by 

Red Hat Software
	Funding for the Building #3 part of the project

Symbios Logic (Now LSI)
	Host adapters, hints, known to work platforms when I hit
	compatibility problems

BoxHill Corporation
	Loan of initial FibreChannel disk array used for development work.

European Comission
	Funding the work done by the University of Helsinki

SysKonnect
        Loan of FDDI and Gigabit Ethernet cards

ASUSTeK
        Loan of I2O motherboard 

Promise
	Providing a Supertrak 100 board and support info

DPT
	Providing a DPT smartraid I2O card (use dpt_i2o for this
	board however)

STATUS:
o	Should be stable for x86 32bit

KNOWN ISSUES:
o	Reports that intel boards die if you load i2o_block and i2o_scsi
o	Some promise cards need firmware updates

TO DO:

General:
o	Finish 64bit and big endian cleanup
o	Switch to new PCI mapping layer throughout
o	Hotswap of controllers
o	Provide hidden address space if asked
o	Long term message flow control
o	PCI IOP's without interrupts are not supported yet
o	Push FAIL handling into the core
o	DDM control interfaces for module load etc

Block:
o	Multiple major numbers (problem goes away in 2.5)
o	Power management
o	Finish Media changers

SCSI:

Lan:	
o	Performance tuning
o	Test Fibre Channel code

Tape:
o	Anyone seen anything implementing this ?