jthiessen@penguincomputing.com [PATCH] I2C: adm1026.c fixes ChangeSet 1.2329.2.4, 2005/01/14 14:42:28-08:00, jthiessen@penguincomputing.com [PATCH] I2C: adm1026.c fixes Ok, take 3 on the adm1026 patch. In this patch: (1) Code has been added which ensures that the fan divisor registers are properly read into the data structure before fan minimum speeds are determined. This prevents a possible divide by zero error. The line which reads the hardware default fan divisor values has been reformatted as suggested by Andreas Dilger to make the intent of the statement clearer. (2) In a similar spirit, an unecessary carriage return from a "dev_dbg" statement in the adm1026_print_gpio() function has been elminated, shortening the statement to a single line and making the code easier to read. Signed-off-by: Justin Thiessen drivers/i2c/chips/adm1026.c | 11 +++++++++-- 1 files changed, 9 insertions(+), 2 deletions(-) diff -Nru a/drivers/i2c/chips/adm1026.c b/drivers/i2c/chips/adm1026.c --- a/drivers/i2c/chips/adm1026.c 2005-01-17 13:20:53 -08:00 +++ b/drivers/i2c/chips/adm1026.c 2005-01-17 13:20:53 -08:00 @@ -452,6 +452,14 @@ client->id, value); data->config1 = value; adm1026_write_value(client, ADM1026_REG_CONFIG1, value); + + /* initialize fan_div[] to hardware defaults */ + value = adm1026_read_value(client, ADM1026_REG_FAN_DIV_0_3) | + (adm1026_read_value(client, ADM1026_REG_FAN_DIV_4_7) << 8); + for (i = 0;i <= 7;++i) { + data->fan_div[i] = DIV_FROM_REG(value & 0x03); + value >>= 2; + } } void adm1026_print_gpio(struct i2c_client *client) @@ -459,8 +467,7 @@ struct adm1026_data *data = i2c_get_clientdata(client); int i; - dev_dbg(&client->dev, "(%d): GPIO config is:", - client->id); + dev_dbg(&client->dev, "(%d): GPIO config is:", client->id); for (i = 0;i <= 7;++i) { if (data->config2 & (1 << i)) { dev_dbg(&client->dev, "\t(%d): %sGP%s%d\n", client->id,