Table of Contents
Hardware interrupts usually communicate with a tasklet or softirq. Frequently this involves putting work in a queue, which the softirq will take out.
If a hardware irq handler shares data with a softirq, you have
two concerns. Firstly, the softirq processing can be
interrupted by a hardware interrupt, and secondly, the
critical region could be entered by a hardware interrupt on
another CPU. This is where
used. It is defined to disable interrupts on that cpu, then grab
spin_unlock_irq() does the reverse.
The irq handler does not to use
spin_lock_irq(), because the softirq cannot
run while the irq handler is running: it can use
spin_lock(), which is slightly faster. The
only exception would be if a different hardware irq handler uses
the same lock:
spin_lock_irq() will stop
that from interrupting us.
This works perfectly for UP as well: the spin lock vanishes,
and this macro simply becomes
protects you from the softirq/tasklet/BH being run.
include/linux/spinlock.h) is a variant
which saves whether interrupts were on or off in a flags word,
which is passed to
means that the same code can be used inside an hard irq handler (where
interrupts are already off) and in softirqs (where the irq
disabling is required).
Note that softirqs (and hence tasklets and timers) are run on
return from hardware interrupts, so
spin_lock_irq() also stops these. In that
spin_lock_irqsave() is the most
general and powerful locking function.