Ordering I/O writes to memory-mapped addresses¶
On some platforms, so-called memory-mapped I/O is weakly ordered. On such platforms, driver writers are responsible for ensuring that I/O writes to memory-mapped addresses on their device arrive in the order intended. This is typically done by reading a 'safe' device or bridge register, causing the I/O chipset to flush pending writes to the device before any reads are posted. A driver would usually use this technique immediately prior to the exit of a critical section of code protected by spinlocks. This would ensure that subsequent writes to I/O space arrived only after all prior writes (much like a memory barrier op, mb(), only with respect to I/O).
A more concrete example from a hypothetical device driver:
...
CPU A: spin_lock_irqsave(&dev_lock, flags)
CPU A: val = readl(my_status);
CPU A: ...
CPU A: writel(newval, ring_ptr);
CPU A: spin_unlock_irqrestore(&dev_lock, flags)
...
CPU B: spin_lock_irqsave(&dev_lock, flags)
CPU B: val = readl(my_status);
CPU B: ...
CPU B: writel(newval2, ring_ptr);
CPU B: spin_unlock_irqrestore(&dev_lock, flags)
...
In the case above, the device may receive newval2 before it receives newval, which could cause problems. Fixing it is easy enough though:
...
CPU A: spin_lock_irqsave(&dev_lock, flags)
CPU A: val = readl(my_status);
CPU A: ...
CPU A: writel(newval, ring_ptr);
CPU A: (void)readl(safe_register); /* maybe a config register? */
CPU A: spin_unlock_irqrestore(&dev_lock, flags)
...
CPU B: spin_lock_irqsave(&dev_lock, flags)
CPU B: val = readl(my_status);
CPU B: ...
CPU B: writel(newval2, ring_ptr);
CPU B: (void)readl(safe_register); /* maybe a config register? */
CPU B: spin_unlock_irqrestore(&dev_lock, flags)
Here, the reads from safe_register will cause the I/O chipset to flush any pending writes before actually posting the read to the chipset, preventing possible data corruption.