Kernel driver g760a

Supported chips:

Author: Herbert Valerio Riedel <hvr@gnu.org>

Description

The GMT G760A Fan Speed PWM Controller is connected directly to a fan and performs closed-loop control of the fan speed.

The fan speed is programmed by setting the period via 'pwm1' of two consecutive speed pulses. The period is defined in terms of clock cycle counts of an assumed 32kHz clock source.

Setting a period of 0 stops the fan; setting the period to 255 sets fan to maximum speed.

The measured fan rotation speed returned via 'fan1_input' is derived from the measured speed pulse period by assuming again a 32kHz clock source and a 2 pulse-per-revolution fan.

The 'alarms' file provides access to the two alarm bits provided by the G760A chip's status register: Bit 0 is set when the actual fan speed differs more than 20% with respect to the programmed fan speed; bit 1 is set when fan speed is below 1920 RPM.

The g760a driver will not update its values more frequently than every other second; reading them more often will do no harm, but will return 'old' values.