Driver for PCI Endpoint Test Function

This driver should be used as a host side driver if the root complex is connected to a configurable PCI endpoint running pci_epf_test function driver configured according to 1.

The "pci_endpoint_test" driver can be used to perform the following tests.

The PCI driver for the test device performs the following tests:

  1. verifying addresses programmed in BAR

  2. raise legacy IRQ

  3. raise MSI IRQ

  4. raise MSI-X IRQ

  5. read data

  6. write data

  7. copy data

This misc driver creates /dev/pci-endpoint-test.<num> for every pci_epf_test function connected to the root complex and "ioctls" should be used to perform the above tests.

ioctl

PCITEST_BAR:

Tests the BAR. The number of the BAR to be tested should be passed as argument.

PCITEST_LEGACY_IRQ:

Tests legacy IRQ

PCITEST_MSI:

Tests message signalled interrupts. The MSI number to be tested should be passed as argument.

PCITEST_MSIX:

Tests message signalled interrupts. The MSI-X number to be tested should be passed as argument.

PCITEST_SET_IRQTYPE:

Changes driver IRQ type configuration. The IRQ type should be passed as argument (0: Legacy, 1:MSI, 2:MSI-X).

PCITEST_GET_IRQTYPE:

Gets driver IRQ type configuration.

PCITEST_WRITE:

Perform write tests. The size of the buffer should be passed as argument.

PCITEST_READ:

Perform read tests. The size of the buffer should be passed as argument.

PCITEST_COPY:

Perform read tests. The size of the buffer should be passed as argument.

1

PCI Test Endpoint Function