BeOS filesystem for Linux¶
Document last updated: Dec 6, 2001
Warning¶
Make sure you understand that this is alpha software. This means that the implementation is neither complete nor well-tested.
I DISCLAIM ALL RESPONSIBILITY FOR ANY POSSIBLE BAD EFFECTS OF THIS CODE!
License¶
This software is covered by the GNU General Public License. See the file COPYING for the complete text of the license. Or the GNU website: <http://www.gnu.org/licenses/licenses.html>
What is this Driver?¶
This module implements the native filesystem of BeOS http://www.beincorporated.com/ for the linux 2.4.1 and later kernels. Currently it is a read-only implementation.
Which is it, BFS or BEFS?¶
Be, Inc said, "BeOS Filesystem is officially called BFS, not BeFS". But Unixware Boot Filesystem is called bfs, too. And they are already in the kernel. Because of this naming conflict, on Linux the BeOS filesystem is called befs.
How to Install¶
step 1. Install the BeFS patch into the source code tree of linux.
Apply the patchfile to your kernel source tree. Assuming that your kernel source is in /foo/bar/linux and the patchfile is called patch-befs-xxx, you would do the following:
cd /foo/bar/linux patch -p1 < /path/to/patch-befs-xxx
if the patching step fails (i.e. there are rejected hunks), you can try to figure it out yourself (it shouldn't be hard), or mail the maintainer (Will Dyson <will_dyson@pobox.com>) for help.
step 2. Configuration & make kernel
The linux kernel has many compile-time options. Most of them are beyond the scope of this document. I suggest the Kernel-HOWTO document as a good general reference on this topic. http://www.linuxdocs.org/HOWTOs/Kernel-HOWTO-4.html
However, to use the BeFS module, you must enable it at configure time:
cd /foo/bar/linux
make menuconfig (or xconfig)
The BeFS module is not a standard part of the linux kernel, so you must first enable support for experimental code under the "Code maturity level" menu.
Then, under the "Filesystems" menu will be an option called "BeFS filesystem (experimental)", or something like that. Enable that option (it is fine to make it a module).
Save your kernel configuration and then build your kernel.
step 3. Install
See the kernel howto <http://www.linux.com/howto/Kernel-HOWTO.html> for instructions on this critical step.
Using BFS¶
To use the BeOS filesystem, use filesystem type 'befs'.
ex:
mount -t befs /dev/fd0 /beos
Mount Options¶
uid=nnn |
All files in the partition will be owned by user id nnn. |
gid=nnn |
All files in the partition will be in group nnn. |
iocharset=xxx |
Use xxx as the name of the NLS translation table. |
debug |
The driver will output debugging information to the syslog. |
How to Get Lastest Version¶
The latest version is currently available at: <http://befs-driver.sourceforge.net/>
Any Known Bugs?¶
As of Jan 20, 2002:
None
Special Thanks¶
Dominic Giampalo ... Writing "Practical file system design with Be filesystem"
Hiroyuki Yamada ... Testing LinuxPPC.