7.61. ioctl VIDIOC_SUBDEV_G_ROUTING, VIDIOC_SUBDEV_S_ROUTING

7.61.1. Name

VIDIOC_SUBDEV_G_ROUTING - VIDIOC_SUBDEV_S_ROUTING - Get or set routing between streams of media pads in a media entity.

7.61.2. Synopsis

VIDIOC_SUBDEV_G_ROUTING

int ioctl(int fd, VIDIOC_SUBDEV_G_ROUTING, struct v4l2_subdev_routing *argp)

VIDIOC_SUBDEV_S_ROUTING

int ioctl(int fd, VIDIOC_SUBDEV_S_ROUTING, struct v4l2_subdev_routing *argp)

7.61.3. Arguments

fd

File descriptor returned by open().

argp

Pointer to struct v4l2_subdev_routing.

7.61.4. Description

These ioctls are used to get and set the routing in a media entity. The routing configuration determines the flows of data inside an entity.

Drivers report their current routing tables using the VIDIOC_SUBDEV_G_ROUTING ioctl and application may enable or disable routes with the VIDIOC_SUBDEV_S_ROUTING ioctl, by adding or removing routes and setting or clearing flags of the flags field of a struct v4l2_subdev_route.

All stream configurations are reset when VIDIOC_SUBDEV_S_ROUTING is called. This means that the userspace must reconfigure all streams after calling the ioctl with e.g. VIDIOC_SUBDEV_S_FMT.

Only subdevices which have both sink and source pads can support routing.

When inspecting routes through VIDIOC_SUBDEV_G_ROUTING and the application provided num_routes is not big enough to contain all the available routes the subdevice exposes, drivers return the ENOSPC error code and adjust the value of the num_routes field. Application should then reserve enough memory for all the route entries and call VIDIOC_SUBDEV_G_ROUTING again.

type v4l2_subdev_routing
struct v4l2_subdev_routing

__u32

which

Format to modified, from enum v4l2_subdev_format_whence.

struct v4l2_subdev_route

routes[]

Array of struct v4l2_subdev_route entries

__u32

num_routes

Number of entries of the routes array

__u32

reserved[5]

Reserved for future extensions. Applications and drivers must set the array to zero.

type v4l2_subdev_route
struct v4l2_subdev_route

__u32

sink_pad

Sink pad number.

__u32

sink_stream

Sink pad stream number.

__u32

source_pad

Source pad number.

__u32

source_stream

Source pad stream number.

__u32

flags

Route enable/disable flags v4l2_subdev_routing_flags.

__u32

reserved[5]

Reserved for future extensions. Applications and drivers must set the array to zero.

enum v4l2_subdev_routing_flags

V4L2_SUBDEV_ROUTE_FL_ACTIVE

0x0001

The route is enabled. Set by applications.

7.61.5. Return Value

On success 0 is returned, on error -1 and the errno variable is set appropriately. The generic error codes are described at the Generic Error Codes chapter.

ENOSPC

The application provided num_routes is not big enough to contain all the available routes the subdevice exposes.

EINVAL

The sink or source pad identifiers reference a non-existing pad, or reference pads of different types (ie. the sink_pad identifiers refers to a source pad) or the sink or source stream identifiers reference a non-existing stream on the sink or source pad.

E2BIG

The application provided num_routes for VIDIOC_SUBDEV_S_ROUTING is larger than the number of routes the driver can handle.