Kernel driver ltc4245

Supported chips:

Author: Ira W. Snyder <iws@ovro.caltech.edu>

Description

The LTC4245 controller allows a board to be safely inserted and removed from a live backplane in multiple supply systems such as CompactPCI and PCI Express.

Usage Notes

This driver does not probe for LTC4245 devices, due to the fact that some of the possible addresses are unfriendly to probing. You will have to instantiate the devices explicitly.

Example: the following will load the driver for an LTC4245 at address 0x23 on I2C bus #1:

$ modprobe ltc4245
$ echo ltc4245 0x23 > /sys/bus/i2c/devices/i2c-1/new_device

Sysfs entries

The LTC4245 has built-in limits for over and under current warnings. This makes it very likely that the reference circuit will be used.

This driver uses the values in the datasheet to change the register values into the values specified in the sysfs-interface document. The current readings rely on the sense resistors listed in Table 2: "Sense Resistor Values".

in1_input

12v input voltage (mV)

in2_input

5v input voltage (mV)

in3_input

3v input voltage (mV)

in4_input

Vee (-12v) input voltage (mV)

in1_min_alarm

12v input undervoltage alarm

in2_min_alarm

5v input undervoltage alarm

in3_min_alarm

3v input undervoltage alarm

in4_min_alarm

Vee (-12v) input undervoltage alarm

curr1_input

12v current (mA)

curr2_input

5v current (mA)

curr3_input

3v current (mA)

curr4_input

Vee (-12v) current (mA)

curr1_max_alarm

12v overcurrent alarm

curr2_max_alarm

5v overcurrent alarm

curr3_max_alarm

3v overcurrent alarm

curr4_max_alarm

Vee (-12v) overcurrent alarm

in5_input

12v output voltage (mV)

in6_input

5v output voltage (mV)

in7_input

3v output voltage (mV)

in8_input

Vee (-12v) output voltage (mV)

in5_min_alarm

12v output undervoltage alarm

in6_min_alarm

5v output undervoltage alarm

in7_min_alarm

3v output undervoltage alarm

in8_min_alarm

Vee (-12v) output undervoltage alarm

in9_input

GPIO voltage data (see note 1)

in10_input

GPIO voltage data (see note 1)

in11_input

GPIO voltage data (see note 1)

power1_input

12v power usage (mW)

power2_input

5v power usage (mW)

power3_input

3v power usage (mW)

power4_input

Vee (-12v) power usage (mW)

Note 1

If you have NOT configured the driver to sample all GPIO pins as analog voltages, then the in10_input and in11_input sysfs attributes will not be created. The driver will sample the GPIO pin that is currently connected to the ADC as an analog voltage, and report the value in in9_input.

If you have configured the driver to sample all GPIO pins as analog voltages, then they will be sampled in round-robin fashion. If userspace reads too slowly, -EAGAIN will be returned when you read the sysfs attribute containing the sensor reading.

The LTC4245 chip can be configured to sample all GPIO pins with two methods:

  1. platform data -- see include/linux/platform_data/ltc4245.h

  2. OF device tree -- add the "ltc4245,use-extra-gpios" property to each chip

The default mode of operation is to sample a single GPIO pin.