Kernel driver pli1209bc

Supported chips:

Authors:

Description

The Vicor PLI1209BC is an isolated digital power system supervisor that provides a communication interface between a host processor and one Bus Converter Module (BCM). The PLI communicates with a system controller via a PMBus compatible interface over an isolated UART interface. Through the PLI, the host processor can configure, set protection limits, and monitor the BCM.

Sysfs entries

in1_label

“vin2”

in1_input

Input voltage.

in1_rated_min

Minimum rated input voltage.

in1_rated_max

Maximum rated input voltage.

in1_max

Maximum input voltage.

in1_max_alarm

Input voltage high alarm.

in1_crit

Critical input voltage.

in1_crit_alarm

Input voltage critical alarm.

in2_label

“vout2”

in2_input

Output voltage.

in2_rated_min

Minimum rated output voltage.

in2_rated_max

Maximum rated output voltage.

in2_alarm

Output voltage alarm

curr1_label

“iin2”

curr1_input

Input current.

curr1_max

Maximum input current.

curr1_max_alarm

Maximum input current high alarm.

curr1_crit

Critical input current.

curr1_crit_alarm

Input current critical alarm.

curr2_label

“iout2”

curr2_input

Output current.

curr2_crit

Critical output current.

curr2_crit_alarm

Output current critical alarm.

curr2_max

Maximum output current.

curr2_max_alarm

Output current high alarm.

power1_label

“pin2”

power1_input

Input power.

power1_alarm

Input power alarm.

power2_label

“pout2”

power2_input

Output power.

power2_rated_max

Maximum rated output power.

temp1_input

Die temperature.

temp1_alarm

Die temperature alarm.

temp1_max

Maximum die temperature.

temp1_max_alarm

Die temperature high alarm.

temp1_crit

Critical die temperature.

temp1_crit_alarm

Die temperature critical alarm.