.. Permission is granted to copy, distribute and/or modify this .. document under the terms of the GNU Free Documentation License, .. Version 1.1 or any later version published by the Free Software .. Foundation, with no Invariant Sections, no Front-Cover Texts .. and no Back-Cover Texts. A copy of the license is included at .. Documentation/userspace-api/media/fdl-appendix.rst. .. .. TODO: replace it to GFDL-1.1-or-later WITH no-invariant-sections .. _VIDIOC_QUERYSTD: ********************************************* ioctl VIDIOC_QUERYSTD, VIDIOC_SUBDEV_QUERYSTD ********************************************* Name ==== VIDIOC_QUERYSTD - VIDIOC_SUBDEV_QUERYSTD - Sense the video standard received by the current input Synopsis ======== .. c:function:: int ioctl( int fd, VIDIOC_QUERYSTD, v4l2_std_id *argp ) :name: VIDIOC_QUERYSTD .. c:function:: int ioctl( int fd, VIDIOC_SUBDEV_QUERYSTD, v4l2_std_id *argp ) :name: VIDIOC_SUBDEV_QUERYSTD Arguments ========= ``fd`` File descriptor returned by :ref:`open() `. ``argp`` Pointer to :c:type:`v4l2_std_id`. Description =========== The hardware may be able to detect the current video standard automatically. To do so, applications call :ref:`VIDIOC_QUERYSTD` with a pointer to a :ref:`v4l2_std_id ` type. The driver stores here a set of candidates, this can be a single flag or a set of supported standards if for example the hardware can only distinguish between 50 and 60 Hz systems. If no signal was detected, then the driver will return V4L2_STD_UNKNOWN. When detection is not possible or fails, the set must contain all standards supported by the current video input or output. .. note:: Drivers shall *not* switch the video standard automatically if a new video standard is detected. Instead, drivers should send the ``V4L2_EVENT_SOURCE_CHANGE`` event (if they support this) and expect that userspace will take action by calling :ref:`VIDIOC_QUERYSTD`. The reason is that a new video standard can mean different buffer sizes as well, and you cannot change buffer sizes on the fly. In general, applications that receive the Source Change event will have to call :ref:`VIDIOC_QUERYSTD`, and if the detected video standard is valid they will have to stop streaming, set the new standard, allocate new buffers and start streaming again. Return Value ============ On success 0 is returned, on error -1 and the ``errno`` variable is set appropriately. The generic error codes are described at the :ref:`Generic Error Codes ` chapter. ENODATA Standard video timings are not supported for this input or output.