Adaptec dpti driver¶
Redistribution and use in source form, with or without modification, are permitted provided that redistributions of source code must retain the above copyright notice, this list of conditions and the following disclaimer.
This software is provided
as is by Adaptec and
any express or implied warranties, including, but not limited to, the
implied warranties of merchantability and fitness for a particular purpose,
are disclaimed. In no event shall Adaptec be
liable for any direct, indirect, incidental, special, exemplary or
consequential damages (including, but not limited to, procurement of
substitute goods or services; loss of use, data, or profits; or business
interruptions) however caused and on any theory of liability, whether in
contract, strict liability, or tort (including negligence or otherwise)
arising in any way out of the use of this driver software, even if advised
of the possibility of such damage.
This driver supports the Adaptec I2O RAID and DPT SmartRAID V I2O boards.
The original linux driver was ported to Linux by Karen White while at Dell Computer. It was ported from Bob Pasteur’s (of DPT) original non-Linux driver. Mark Salyzyn and Bob Pasteur consulted on the original driver.
2.0 version of the driver by Deanna Bonds and Mark Salyzyn.
The driver was originally ported to linux version 2.0.34
|V2.0||Rewrite of driver. Re-architectured based on i2o subsystem. This was the first full GPL version since the last version used i2osig headers which were not GPL. Developer Testing version.|
|V2.2||First released version|
First version ready to be submitted to be embedded in the kernel
- Add 64 bit Scatter Gather when compiled on 64 bit architectures
- Add sparse lun scanning
- Add code that checks if a device that had been taken offline is now online (at the FW level) when test unit ready or inquiry command from scsi-core
- Add proc read interface
- busrescan command
- rescan command
- Add code to rescan routine that notifies scsi-core about new devices
- Add support for C-PCI (hotplug stuff)
- Add ioctl passthru error recovery
The DPT card optimizes the order of processing commands. Consequently, a command may take up to 6 minutes to complete after it has been sent to the board.
The files dpti_ioctl.h dptsig.h osd_defs.h osd_util.h sys_info.h are part of the interface files for Adaptec’s management routines. These define the structures used in the ioctls. They are written to be portable. They are hard to read, but I need to use them ‘as is’ or I can miss changes in the interface.