Kernel driver tmp401 ==================== Supported chips: * Texas Instruments TMP401 Prefix: 'tmp401' Addresses scanned: I2C 0x4c Datasheet: http://focus.ti.com/docs/prod/folders/print/tmp401.html * Texas Instruments TMP411 Prefix: 'tmp411' Addresses scanned: I2C 0x4c, 0x4d, 0x4e Datasheet: http://focus.ti.com/docs/prod/folders/print/tmp411.html * Texas Instruments TMP431 Prefix: 'tmp431' Addresses scanned: I2C 0x4c, 0x4d Datasheet: http://focus.ti.com/docs/prod/folders/print/tmp431.html * Texas Instruments TMP432 Prefix: 'tmp432' Addresses scanned: I2C 0x4c, 0x4d Datasheet: http://focus.ti.com/docs/prod/folders/print/tmp432.html * Texas Instruments TMP435 Prefix: 'tmp435' Addresses scanned: I2C 0x48 - 0x4f Datasheet: http://focus.ti.com/docs/prod/folders/print/tmp435.html * Texas Instruments TMP461 Prefix: 'tmp461' Datasheet: http://www.ti.com/product/tmp461 Authors: - Hans de Goede - Andre Prendel Description ----------- This driver implements support for Texas Instruments TMP401, TMP411, TMP431, TMP432, TMP435, and TMP461 chips. These chips implement one or two remote and one local temperature sensors. Temperature is measured in degrees Celsius. Resolution of the remote sensor is 0.0625 degree. Local sensor resolution can be set to 0.5, 0.25, 0.125 or 0.0625 degree (not supported by the driver so far, so using the default resolution of 0.5 degree). The driver provides the common sysfs-interface for temperatures (see Documentation/hwmon/sysfs-interface.rst under Temperatures). The TMP411 and TMP431 chips are compatible with TMP401. TMP411 provides some additional features. * Minimum and Maximum temperature measured since power-on, chip-reset Exported via sysfs attributes tempX_lowest and tempX_highest. * Reset of historical minimum/maximum temperature measurements Exported via sysfs attribute temp_reset_history. Writing 1 to this file triggers a reset. TMP432 is compatible with TMP401 and TMP431. It supports two external temperature sensors. TMP461 is compatible with TMP401. It supports offset correction that is applied to the remote sensor. * Sensor offset values are temperature values Exported via sysfs attribute tempX_offset