Kernel driver w1_ds28e04

Supported chips:

  • Maxim DS28E04-100 4096-Bit Addressable 1-Wire EEPROM with PIO

supported family codes:

W1_FAMILY_DS28E04 0x1C

Author: Markus Franke, <franke.m@sebakmt.com> <franm@hrz.tu-chemnitz.de>

Description

Support is provided through the sysfs files “eeprom” and “pio”. CRC checking during memory accesses can optionally be enabled/disabled via the device attribute “crccheck”. The strong pull-up can optionally be enabled/disabled via the module parameter “w1_strong_pullup”.

Memory Access

A read operation on the “eeprom” file reads the given amount of bytes from the EEPROM of the DS28E04.

A write operation on the “eeprom” file writes the given byte sequence to the EEPROM of the DS28E04. If CRC checking mode is enabled only fully aligned blocks of 32 bytes with valid CRC16 values (in bytes 30 and 31) are allowed to be written.

PIO Access

The 2 PIOs of the DS28E04-100 are accessible via the “pio” sysfs file.

The current status of the PIO’s is returned as an 8 bit value. Bit 0/1 represent the state of PIO_0/PIO_1. Bits 2..7 do not care. The PIO’s are driven low-active, i.e. the driver delivers/expects low-active values.