Kernel driver ltc3815

Supported chips:

Author: Guenter Roeck <linux@roeck-us.net>

Description

LTC3815 is a Monolithic Synchronous DC/DC Step-Down Converter.

Usage Notes

This driver does not probe for PMBus devices. You will have to instantiate devices explicitly.

Example: the following commands will load the driver for an LTC3815 at address 0x20 on I2C bus #1:

# modprobe ltc3815
# echo ltc3815 0x20 > /sys/bus/i2c/devices/i2c-1/new_device

Sysfs attributes

in1_label “vin”
in1_input Measured input voltage.
in1_alarm Input voltage alarm.
in1_highest Highest input voltage.
in1_reset_history Reset input voltage history.
in2_label “vout1”.
in2_input Measured output voltage.
in2_alarm Output voltage alarm.
in2_highest Highest output voltage.
in2_reset_history Reset output voltage history.
temp1_input Measured chip temperature.
temp1_alarm Temperature alarm.
temp1_highest Highest measured temperature.
temp1_reset_history Reset temperature history.
curr1_label “iin”.
curr1_input Measured input current.
curr1_highest Highest input current.
curr1_reset_history Reset input current history.
curr2_label “iout1”.
curr2_input Measured output current.
curr2_alarm Output current alarm.
curr2_highest Highest output current.
curr2_reset_history Reset output current history.