3.1. Demux Data Types

enum dmx_output

Output for the demux.

Constants

DMX_OUT_DECODER
Streaming directly to decoder.
DMX_OUT_TAP
Output going to a memory buffer (to be retrieved via the read command). Delivers the stream output to the demux device on which the ioctl is called.
DMX_OUT_TS_TAP
Output multiplexed into a new TS (to be retrieved by reading from the logical DVR device). Routes output to the logical DVR device /dev/dvb/adapter?/dvr?, which delivers a TS multiplexed from all filters for which DMX_OUT_TS_TAP was specified.
DMX_OUT_TSDEMUX_TAP
Like DMX_OUT_TS_TAP but retrieved from the DMX device.
enum dmx_input

Input from the demux.

Constants

DMX_IN_FRONTEND
Input from a front-end device.
DMX_IN_DVR
Input from the logical DVR device.
enum dmx_ts_pes

type of the PES filter.

Constants

DMX_PES_AUDIO0
first audio PID. Also referred as DMX_PES_AUDIO.
DMX_PES_VIDEO0
first video PID. Also referred as DMX_PES_VIDEO.
DMX_PES_TELETEXT0
first teletext PID. Also referred as DMX_PES_TELETEXT.
DMX_PES_SUBTITLE0
first subtitle PID. Also referred as DMX_PES_SUBTITLE.
DMX_PES_PCR0
first Program Clock Reference PID. Also referred as DMX_PES_PCR.
DMX_PES_AUDIO1
second audio PID.
DMX_PES_VIDEO1
second video PID.
DMX_PES_TELETEXT1
second teletext PID.
DMX_PES_SUBTITLE1
second subtitle PID.
DMX_PES_PCR1
second Program Clock Reference PID.
DMX_PES_AUDIO2
third audio PID.
DMX_PES_VIDEO2
third video PID.
DMX_PES_TELETEXT2
third teletext PID.
DMX_PES_SUBTITLE2
third subtitle PID.
DMX_PES_PCR2
third Program Clock Reference PID.
DMX_PES_AUDIO3
fourth audio PID.
DMX_PES_VIDEO3
fourth video PID.
DMX_PES_TELETEXT3
fourth teletext PID.
DMX_PES_SUBTITLE3
fourth subtitle PID.
DMX_PES_PCR3
fourth Program Clock Reference PID.
DMX_PES_OTHER
any other PID.
struct dmx_filter

Specifies a section header filter.

Definition

struct dmx_filter {
  __u8 filter[DMX_FILTER_SIZE];
  __u8 mask[DMX_FILTER_SIZE];
  __u8 mode[DMX_FILTER_SIZE];
};

Members

filter
bit array with bits to be matched at the section header.
mask
bits that are valid at the filter bit array.
mode
mode of match: if bit is zero, it will match if equal (positive match); if bit is one, it will match if the bit is negated.

Note

All arrays in this struct have a size of DMX_FILTER_SIZE (16 bytes).

struct dmx_sct_filter_params

Specifies a section filter.

Definition

struct dmx_sct_filter_params {
  __u16 pid;
  struct dmx_filter filter;
  __u32 timeout;
  __u32 flags;
#define DMX_CHECK_CRC       1;
#define DMX_ONESHOT         2;
#define DMX_IMMEDIATE_START 4;
};

Members

pid
PID to be filtered.
filter
section header filter, as defined by struct dmx_filter.
timeout
maximum time to filter, in milliseconds.
flags
extra flags for the section filter.

Description

Carries the configuration for a MPEG-TS section filter.

The flags can be:

  • DMX_CHECK_CRC - only deliver sections where the CRC check succeeded;
  • DMX_ONESHOT - disable the section filter after one section has been delivered;
  • DMX_IMMEDIATE_START - Start filter immediately without requiring a DMX_START.
struct dmx_pes_filter_params

Specifies Packetized Elementary Stream (PES) filter parameters.

Definition

struct dmx_pes_filter_params {
  __u16 pid;
  enum dmx_input  input;
  enum dmx_output output;
  enum dmx_ts_pes pes_type;
  __u32 flags;
};

Members

pid
PID to be filtered.
input
Demux input, as specified by enum dmx_input.
output
Demux output, as specified by enum dmx_output.
pes_type
Type of the pes filter, as specified by enum dmx_pes_type.
flags
Demux PES flags.
struct dmx_stc

Stores System Time Counter (STC) information.

Definition

struct dmx_stc {
  unsigned int num;
  unsigned int base;
  __u64 stc;
};

Members

num
input data: number of the STC, from 0 to N.
base
output: divisor for STC to get 90 kHz clock.
stc
output: stc in base * 90 kHz units.
enum dmx_buffer_flags

DMX memory-mapped buffer flags

Constants

DMX_BUFFER_FLAG_HAD_CRC32_DISCARD
Indicates that the Kernel discarded one or more frames due to wrong CRC32 checksum.
DMX_BUFFER_FLAG_TEI
Indicates that the Kernel has detected a Transport Error indicator (TEI) on a filtered pid.
DMX_BUFFER_PKT_COUNTER_MISMATCH
Indicates that the Kernel has detected a packet counter mismatch on a filtered pid.
DMX_BUFFER_FLAG_DISCONTINUITY_DETECTED
Indicates that the Kernel has detected one or more frame discontinuity.
DMX_BUFFER_FLAG_DISCONTINUITY_INDICATOR
Received at least one packet with a frame discontinuity indicator.
struct dmx_buffer

dmx buffer info

Definition

struct dmx_buffer {
  __u32 index;
  __u32 bytesused;
  __u32 offset;
  __u32 length;
  __u32 flags;
  __u32 count;
};

Members

index
id number of the buffer
bytesused
number of bytes occupied by data in the buffer (payload);
offset
for buffers with memory == DMX_MEMORY_MMAP; offset from the start of the device memory for this plane, (or a “cookie” that should be passed to mmap() as offset)
length
size in bytes of the buffer
flags
bit array of buffer flags as defined by enum dmx_buffer_flags. Filled only at DMX_DQBUF.
count
monotonic counter for filled buffers. Helps to identify data stream loses. Filled only at DMX_DQBUF.

Description

Contains data exchanged by application and driver using one of the streaming I/O methods.

Please notice that, for DMX_QBUF, only index should be filled. On DMX_DQBUF calls, all fields will be filled by the Kernel.

struct dmx_requestbuffers

request dmx buffer information

Definition

struct dmx_requestbuffers {
  __u32 count;
  __u32 size;
};

Members

count
number of requested buffers,
size
size in bytes of the requested buffer

Description

Contains data used for requesting a dmx buffer. All reserved fields must be set to zero.

struct dmx_exportbuffer

export of dmx buffer as DMABUF file descriptor

Definition

struct dmx_exportbuffer {
  __u32 index;
  __u32 flags;
  __s32 fd;
};

Members

index
id number of the buffer
flags
flags for newly created file, currently only O_CLOEXEC is supported, refer to manual of open syscall for more details
fd
file descriptor associated with DMABUF (set by driver)

Description

Contains data used for exporting a dmx buffer as DMABUF file descriptor. The buffer is identified by a ‘cookie’ returned by DMX_QUERYBUF (identical to the cookie used to mmap() the buffer to userspace). All reserved fields must be set to zero. The field reserved0 is expected to become a structure ‘type’ allowing an alternative layout of the structure content. Therefore this field should not be used for any other extensions.