Kernel driver max16065

Supported chips:

Author: Guenter Roeck <linux@roeck-us.net>

Description

[From datasheets] The MAX16065/MAX16066 flash-configurable system managers monitor and sequence multiple system voltages. The MAX16065/MAX16066 can also accurately monitor (+/-2.5%) one current channel using a dedicated high-side current-sense amplifier. The MAX16065 manages up to twelve system voltages simultaneously, and the MAX16066 manages up to eight supply voltages.

The MAX16067 flash-configurable system manager monitors and sequences multiple system voltages. The MAX16067 manages up to six system voltages simultaneously.

The MAX16068 flash-configurable system manager monitors and manages up to six system voltages simultaneously.

The MAX16070/MAX16071 flash-configurable system monitors supervise multiple system voltages. The MAX16070/MAX16071 can also accurately monitor (+/-2.5%) one current channel using a dedicated high-side current-sense amplifier. The MAX16070 monitors up to twelve system voltages simultaneously, and the MAX16071 monitors up to eight supply voltages.

Each monitored channel has its own low and high critical limits. MAX16065, MAX16066, MAX16070, and MAX16071 support an additional limit which is configurable as either low or high secondary limit. MAX16065, MAX16066, MAX16070, and MAX16071 also support supply current monitoring.

Usage Notes

This driver does not probe for devices, since there is no register which can be safely used to identify the chip. You will have to instantiate the devices explicitly. Please see Documentation/i2c/instantiating-devices for details.

WARNING: Do not access chip registers using the i2cdump command, and do not use any of the i2ctools commands on a command register (0xa5 to 0xac). The chips supported by this driver interpret any access to a command register (including read commands) as request to execute the command in question. This may result in power loss, board resets, and/or Flash corruption. Worst case, your board may turn into a brick.

Sysfs entries

in[0-11]_input Input voltage measurements.
in12_input Voltage on CSP (Current Sense Positive) pin. Only if the chip supports current sensing and if current sensing is enabled.
in[0-11]_min Low warning limit. Supported on MAX16065, MAX16066, MAX16070, and MAX16071 only.
in[0-11]_max

High warning limit. Supported on MAX16065, MAX16066, MAX16070, and MAX16071 only.

Either low or high warning limits are supported (depending on chip configuration), but not both.

in[0-11]_lcrit Low critical limit.
in[0-11]_crit High critical limit.
in[0-11]_alarm Input voltage alarm.
curr1_input Current sense input; only if the chip supports current sensing and if current sensing is enabled. Displayed current assumes 0.001 Ohm current sense resistor.
curr1_alarm Overcurrent alarm; only if the chip supports current sensing and if current sensing is enabled.