Kernel driver adt7410 ===================== Supported chips: * Analog Devices ADT7410 Prefix: 'adt7410' Addresses scanned: None Datasheet: Publicly available at the Analog Devices website https://www.analog.com/static/imported-files/data_sheets/ADT7410.pdf * Analog Devices ADT7420 Prefix: 'adt7420' Addresses scanned: None Datasheet: Publicly available at the Analog Devices website https://www.analog.com/static/imported-files/data_sheets/ADT7420.pdf * Analog Devices ADT7310 Prefix: 'adt7310' Addresses scanned: None Datasheet: Publicly available at the Analog Devices website https://www.analog.com/static/imported-files/data_sheets/ADT7310.pdf * Analog Devices ADT7320 Prefix: 'adt7320' Addresses scanned: None Datasheet: Publicly available at the Analog Devices website https://www.analog.com/static/imported-files/data_sheets/ADT7320.pdf Author: Hartmut Knaack Description ----------- The ADT7310/ADT7410 is a temperature sensor with rated temperature range of -55°C to +150°C. It has a high accuracy of +/-0.5°C and can be operated at a resolution of 13 bits (0.0625°C) or 16 bits (0.0078°C). The sensor provides an INT pin to indicate that a minimum or maximum temperature set point has been exceeded, as well as a critical temperature (CT) pin to indicate that the critical temperature set point has been exceeded. Both pins can be set up with a common hysteresis of 0°C - 15°C and a fault queue, ranging from 1 to 4 events. Both pins can individually set to be active-low or active-high, while the whole device can either run in comparator mode or interrupt mode. The ADT7410 supports continuous temperature sampling, as well as sampling one temperature value per second or even just get one sample on demand for power saving. Besides, it can completely power down its ADC, if power management is required. The ADT7320/ADT7420 is register compatible, the only differences being the package, a slightly narrower operating temperature range (-40°C to +150°C), and a better accuracy (0.25°C instead of 0.50°C.) The difference between the ADT7310/ADT7320 and ADT7410/ADT7420 is the control interface, the ADT7310 and ADT7320 use SPI while the ADT7410 and ADT7420 use I2C. Configuration Notes ------------------- Since the device uses one hysteresis value, which is an offset to minimum, maximum and critical temperature, it can only be set for temp#_max_hyst. However, temp#_min_hyst and temp#_crit_hyst show their corresponding hysteresis. The device is set to 16 bit resolution and comparator mode. sysfs-Interface --------------- ======================== ==================================================== temp#_input temperature input temp#_min temperature minimum setpoint temp#_max temperature maximum setpoint temp#_crit critical temperature setpoint temp#_min_hyst hysteresis for temperature minimum (read-only) temp#_max_hyst hysteresis for temperature maximum (read/write) temp#_crit_hyst hysteresis for critical temperature (read-only) temp#_min_alarm temperature minimum alarm flag temp#_max_alarm temperature maximum alarm flag temp#_crit_alarm critical temperature alarm flag ======================== ====================================================