Kernel driver stpddc60

Supported chips:

Author: Erik Rosen <erik.rosen@metormote.com>

Description

This driver supports hardware monitoring for ST STPDDC60 controller chip and compatible modules.

The driver is a client driver to the core PMBus driver. Please see Kernel driver pmbus and Documentation.hwmon/pmbus-core for details on PMBus client drivers.

Usage Notes

This driver does not auto-detect devices. You will have to instantiate the devices explicitly. Please see How to instantiate I2C devices for details.

The vout under- and over-voltage limits are set in relation to the commanded output voltage as a positive or negative offset in the interval 50mV to 400mV in 50mV steps. This means that the absolute values of the limits will change when the commanded output voltage changes. Also, care should be taken when writing to those limits since in the worst case the commanded output voltage could change at the same time as the limit is written to, wich will lead to unpredictable results.

Platform data support

The driver supports standard PMBus driver platform data.

Sysfs entries

The following attributes are supported. Vin, iout, pout and temp limits are read-write; all other attributes are read-only.

in1_label

“vin”

in1_input

Measured input voltage.

in1_lcrit

Critical minimum input voltage.

in1_crit

Critical maximum input voltage.

in1_lcrit_alarm

Input voltage critical low alarm.

in1_crit_alarm

Input voltage critical high alarm.

in2_label

“vout1”

in2_input

Measured output voltage.

in2_lcrit

Critical minimum output voltage.

in2_crit

Critical maximum output voltage.

in2_lcrit_alarm

Critical output voltage critical low alarm.

in2_crit_alarm

Critical output voltage critical high alarm.

curr1_label

“iout1”

curr1_input

Measured output current.

curr1_max

Maximum output current.

curr1_max_alarm

Output current high alarm.

curr1_crit

Critical maximum output current.

curr1_crit_alarm

Output current critical high alarm.

power1_label

“pout1”

power1_input

Measured output power.

power1_crit

Critical maximum output power.

power1_crit_alarm

Output power critical high alarm.

temp1_input

Measured maximum temperature of all phases.

temp1_max

Maximum temperature limit.

temp1_max_alarm

High temperature alarm.

temp1_crit

Critical maximum temperature limit.

temp1_crit_alarm

Critical maximum temperature alarm.