ARM Microchip SoCs (aka AT91)

Introduction

This document gives useful information about the ARM Microchip SoCs that are currently supported in Linux Mainline (you know, the one on kernel.org).

It is important to note that the Microchip (previously Atmel) ARM-based MPU product line is historically named “AT91” or “at91” throughout the Linux kernel development process even if this product prefix has completely disappeared from the official Microchip product name. Anyway, files, directories, git trees, git branches/tags and email subject always contain this “at91” sub-string.

AT91 SoCs

Documentation and detailed datasheet for each product are available on the Microchip website: http://www.microchip.com.

Flavors:

Linux kernel information

Linux kernel mach directory: arch/arm/mach-at91 MAINTAINERS entry is: “ARM/Microchip (AT91) SoC support”

Device Tree for AT91 SoCs and boards

All AT91 SoCs are converted to Device Tree. Since Linux 3.19, these products must use this method to boot the Linux kernel.

Work In Progress statement: Device Tree files and Device Tree bindings that apply to AT91 SoCs and boards are considered as “Unstable”. To be completely clear, any at91 binding can change at any time. So, be sure to use a Device Tree Binary and a Kernel Image generated from the same source tree. Please refer to the Devicetree (DT) ABI file for a definition of a “Stable” binding/ABI. This statement will be removed by AT91 MAINTAINERS when appropriate.

Naming conventions and best practice:

  • SoCs Device Tree Source Include files are named after the official name of the product (at91sam9g20.dtsi or sama5d33.dtsi for instance).

  • Device Tree Source Include files (.dtsi) are used to collect common nodes that can be shared across SoCs or boards (sama5d3.dtsi or at91sam9x5cm.dtsi for instance). When collecting nodes for a particular peripheral or topic, the identifier have to be placed at the end of the file name, separated with a “_” (at91sam9x5_can.dtsi or sama5d3_gmac.dtsi for example).

  • board Device Tree Source files (.dts) are prefixed by the string “at91-” so that they can be identified easily. Note that some files are historical exceptions to this rule (sama5d3[13456]ek.dts, usb_a9g20.dts or animeo_ip.dts for example).