6.5.2. LIRC write()

6.5.2.1. Name

lirc-write - Write to a LIRC device

6.5.2.2. Synopsis

#include <unistd.h>
ssize_t write(int fd, void *buf, size_t count)

6.5.2.3. Arguments

fd

File descriptor returned by open().

buf

Buffer with data to be written

count

Number of bytes at the buffer

6.5.2.4. Description

write() writes up to count bytes to the device referenced by the file descriptor fd from the buffer starting at buf.

The exact format of the data depends on what mode a driver is in, use ioctl LIRC_GET_FEATURES to get the supported modes and use ioctls LIRC_GET_SEND_MODE and LIRC_SET_SEND_MODE set the mode.

When in LIRC_MODE_PULSE mode, the data written to the chardev is a pulse/space sequence of integer values. Pulses and spaces are only marked implicitly by their position. The data must start and end with a pulse, therefore, the data must always include an uneven number of samples. The write function blocks until the data has been transmitted by the hardware. If more data is provided than the hardware can send, the driver returns EINVAL.

When in LIRC_MODE_SCANCODE mode, one struct lirc_scancode must be written to the chardev at a time, else EINVAL is returned. Set the desired scancode in the scancode member, and the IR protocol in the rc_proto: member. All other members must be set to 0, else EINVAL is returned. If there is no protocol encoder for the protocol or the scancode is not valid for the specified protocol, EINVAL is returned. The write function blocks until the scancode is transmitted by the hardware.

6.5.2.5. Return Value

On success, the number of bytes written is returned. It is not an error if this number is smaller than the number of bytes requested, or the amount of data required for one frame. On error, -1 is returned, and the errno variable is set appropriately. The generic error codes are described at the Generic Error Codes chapter.