How to set up the Technisat/B2C2 Flexcop devices ================================================ .. note:: This documentation is outdated. Author: Uwe Bugla August 2009 Find out what device you have ----------------------------- Important Notice: The driver does NOT support Technisat USB 2 devices! First start your linux box with a shipped kernel: .. code-block:: none lspci -vvv for a PCI device (lsusb -vvv for an USB device) will show you for example: 02:0b.0 Network controller: Techsan Electronics Co Ltd B2C2 FlexCopII DVB chip / Technisat SkyStar2 DVB card (rev 02) dmesg | grep frontend may show you for example: DVB: registering frontend 0 (Conexant CX24123/CX24109)... Kernel compilation: ------------------- If the Flexcop / Technisat is the only DVB / TV / Radio device in your box get rid of unnecessary modules and check this one: ``Multimedia support`` => ``Customise analog and hybrid tuner modules to build`` In this directory uncheck every driver which is activated there (except ``Simple tuner support`` for ATSC 3rd generation only -> see case 9 please). Then please activate: - Main module part: ``Multimedia support`` => ``DVB/ATSC adapters`` => ``Technisat/B2C2 FlexcopII(b) and FlexCopIII adapters`` #) => ``Technisat/B2C2 Air/Sky/Cable2PC PCI`` (PCI card) or #) => ``Technisat/B2C2 Air/Sky/Cable2PC USB`` (USB 1.1 adapter) and for troubleshooting purposes: #) => ``Enable debug for the B2C2 FlexCop drivers`` - Frontend / Tuner / Demodulator module part: ``Multimedia support`` => ``DVB/ATSC adapters`` => ``Customise the frontend modules to build`` ``Customise DVB frontends`` => - SkyStar DVB-S Revision 2.3: #) => ``Zarlink VP310/MT312/ZL10313 based`` #) => ``Generic I2C PLL based tuners`` - SkyStar DVB-S Revision 2.6: #) => ``ST STV0299 based`` #) => ``Generic I2C PLL based tuners`` - SkyStar DVB-S Revision 2.7: #) => ``Samsung S5H1420 based`` #) => ``Integrant ITD1000 Zero IF tuner for DVB-S/DSS`` #) => ``ISL6421 SEC controller`` - SkyStar DVB-S Revision 2.8: #) => ``Conexant CX24123 based`` #) => ``Conexant CX24113/CX24128 tuner for DVB-S/DSS`` #) => ``ISL6421 SEC controller`` - AirStar DVB-T card: #) => ``Zarlink MT352 based`` #) => ``Generic I2C PLL based tuners`` - CableStar DVB-C card: #) => ``ST STV0297 based`` #) => ``Generic I2C PLL based tuners`` - AirStar ATSC card 1st generation: #) => ``Broadcom BCM3510`` - AirStar ATSC card 2nd generation: #) => ``NxtWave Communications NXT2002/NXT2004 based`` #) => ``Generic I2C PLL based tuners`` - AirStar ATSC card 3rd generation: #) => ``LG Electronics LGDT3302/LGDT3303 based`` #) ``Multimedia support`` => ``Customise analog and hybrid tuner modules to build`` => ``Simple tuner support``