==================== request_firmware API ==================== You would typically load firmware and then load it into your device somehow. The typical firmware work flow is reflected below:: if(request_firmware(&fw_entry, $FIRMWARE, device) == 0) copy_fw_to_device(fw_entry->data, fw_entry->size); release_firmware(fw_entry); Synchronous firmware requests ============================= Synchronous firmware requests will wait until the firmware is found or until an error is returned. request_firmware ---------------- .. kernel-doc:: drivers/base/firmware_class.c :functions: request_firmware request_firmware_direct ----------------------- .. kernel-doc:: drivers/base/firmware_class.c :functions: request_firmware_direct request_firmware_into_buf ------------------------- .. kernel-doc:: drivers/base/firmware_class.c :functions: request_firmware_into_buf Asynchronous firmware requests ============================== Asynchronous firmware requests allow driver code to not have to wait until the firmware or an error is returned. Function callbacks are provided so that when the firmware or an error is found the driver is informed through the callback. request_firmware_nowait() cannot be called in atomic contexts. request_firmware_nowait ----------------------- .. kernel-doc:: drivers/base/firmware_class.c :functions: request_firmware_nowait Considerations for suspend and resume ===================================== During suspend and resume only the built-in firmware and the firmware cache elements of the firmware API can be used. This is managed by fw_pm_notify(). fw_pm_notify ------------ .. kernel-doc:: drivers/base/firmware_class.c :functions: fw_pm_notify request firmware API expected driver use ======================================== Once an API call returns you process the firmware and then release the firmware. For example if you used request_firmware() and it returns, the driver has the firmware image accessible in fw_entry->{data,size}. If something went wrong request_firmware() returns non-zero and fw_entry is set to NULL. Once your driver is done with processing the firmware it can call call release_firmware(fw_entry) to release the firmware image and any related resource.