3. Types and flags used to represent the media graph elements

Media entity types

MEDIA_ENT_F_UNKNOWN and

MEDIA_ENT_F_V4L2_SUBDEV_UNKNOWN

Unknown entity. That generally indicates that a driver didn’t initialize properly the entity, with is a Kernel bug

MEDIA_ENT_F_IO_V4L

Data streaming input and/or output entity.

MEDIA_ENT_F_IO_VBI

V4L VBI streaming input or output entity

MEDIA_ENT_F_IO_SWRADIO

V4L Software Digital Radio (SDR) streaming input or output entity

MEDIA_ENT_F_IO_DTV

DVB Digital TV streaming input or output entity

MEDIA_ENT_F_DTV_DEMOD

Digital TV demodulator entity.

MEDIA_ENT_F_TS_DEMUX

MPEG Transport stream demux entity. Could be implemented on hardware or in Kernelspace by the Linux DVB subsystem.

MEDIA_ENT_F_DTV_CA

Digital TV Conditional Access module (CAM) entity

MEDIA_ENT_F_DTV_NET_DECAP

Digital TV network ULE/MLE desencapsulation entity. Could be implemented on hardware or in Kernelspace

MEDIA_ENT_F_CONN_RF

Connector for a Radio Frequency (RF) signal.

MEDIA_ENT_F_CONN_SVIDEO

Connector for a S-Video signal.

MEDIA_ENT_F_CONN_COMPOSITE

Connector for a RGB composite signal.

MEDIA_ENT_F_CAM_SENSOR

Camera video sensor entity.

MEDIA_ENT_F_FLASH

Flash controller entity.

MEDIA_ENT_F_LENS

Lens controller entity.

MEDIA_ENT_F_ATV_DECODER

Analog video decoder, the basic function of the video decoder is to accept analogue video from a wide variety of sources such as broadcast, DVD players, cameras and video cassette recorders, in either NTSC, PAL, SECAM or HD format, separating the stream into its component parts, luminance and chrominance, and output it in some digital video standard, with appropriate timing signals.

MEDIA_ENT_F_TUNER

Digital TV, analog TV, radio and/or software radio tuner, with consists on a PLL tuning stage that converts radio frequency (RF) signal into an Intermediate Frequency (IF). Modern tuners have internally IF-PLL decoders for audio and video, but older models have those stages implemented on separate entities.

MEDIA_ENT_F_IF_VID_DECODER

IF-PLL video decoder. It receives the IF from a PLL and decodes the analog TV video signal. This is commonly found on some very old analog tuners, like Philips MK3 designs. They all contain a tda9887 (or some software compatible similar chip, like tda9885). Those devices use a different I2C address than the tuner PLL.

MEDIA_ENT_F_IF_AUD_DECODER

IF-PLL sound decoder. It receives the IF from a PLL and decodes the analog TV audio signal. This is commonly found on some very old analog hardware, like Micronas msp3400, Philips tda9840, tda985x, etc. Those devices use a different I2C address than the tuner PLL and should be controlled together with the IF-PLL video decoder.

MEDIA_ENT_F_AUDIO_CAPTURE

Audio Capture Function Entity.

MEDIA_ENT_F_AUDIO_PLAYBACK

Audio Playback Function Entity.

MEDIA_ENT_F_AUDIO_MIXER

Audio Mixer Function Entity.

MEDIA_ENT_F_PROC_VIDEO_COMPOSER

Video composer (blender). An entity capable of video composing must have at least two sink pads and one source pad, and composes input video frames onto output video frames. Composition can be performed using alpha blending, color keying, raster operations (ROP), stitching or any other means.

MEDIA_ENT_F_PROC_VIDEO_PIXEL_FORMATTER

Video pixel formatter. An entity capable of pixel formatting must have at least one sink pad and one source pad. Read pixel formatters read pixels from memory and perform a subset of unpacking, cropping, color keying, alpha multiplication and pixel encoding conversion. Write pixel formatters perform a subset of dithering, pixel encoding conversion and packing and write pixels to memory.

MEDIA_ENT_F_PROC_VIDEO_PIXEL_ENC_CONV

Video pixel encoding converter. An entity capable of pixel enconding conversion must have at least one sink pad and one source pad, and convert the encoding of pixels received on its sink pad(s) to a different encoding output on its source pad(s). Pixel encoding conversion includes but isn’t limited to RGB to/from HSV, RGB to/from YUV and CFA (Bayer) to RGB conversions.

MEDIA_ENT_F_PROC_VIDEO_LUT

Video look-up table. An entity capable of video lookup table processing must have one sink pad and one source pad. It uses the values of the pixels received on its sink pad to look up entries in internal tables and output them on its source pad. The lookup processing can be performed on all components separately or combine them for multi-dimensional table lookups.

MEDIA_ENT_F_PROC_VIDEO_SCALER

Video scaler. An entity capable of video scaling must have at least one sink pad and one source pad, and scale the video frame(s) received on its sink pad(s) to a different resolution output on its source pad(s). The range of supported scaling ratios is entity-specific and can differ between the horizontal and vertical directions (in particular scaling can be supported in one direction only). Binning and skipping are considered as scaling.

MEDIA_ENT_F_PROC_VIDEO_STATISTICS

Video statistics computation (histogram, 3A, ...). An entity capable of statistics computation must have one sink pad and one source pad. It computes statistics over the frames received on its sink pad and outputs the statistics data on its source pad.

Media entity flags
MEDIA_ENT_FL_DEFAULT

Default entity for its type. Used to discover the default audio, VBI and video devices, the default camera sensor, ...

MEDIA_ENT_FL_CONNECTOR

The entity represents a data conector

Media interface types
MEDIA_INTF_T_DVB_FE Device node interface for the Digital TV frontend

typically, /dev/dvb/adapter?/frontend?

MEDIA_INTF_T_DVB_DEMUX Device node interface for the Digital TV demux

typically, /dev/dvb/adapter?/demux?

MEDIA_INTF_T_DVB_DVR Device node interface for the Digital TV DVR

typically, /dev/dvb/adapter?/dvr?

MEDIA_INTF_T_DVB_CA Device node interface for the Digital TV Conditional Access

typically, /dev/dvb/adapter?/ca?

MEDIA_INTF_T_DVB_NET Device node interface for the Digital TV network control

typically, /dev/dvb/adapter?/net?

MEDIA_INTF_T_V4L_VIDEO Device node interface for video (V4L)

typically, /dev/video?

MEDIA_INTF_T_V4L_VBI Device node interface for VBI (V4L)

typically, /dev/vbi?

MEDIA_INTF_T_V4L_RADIO Device node interface for radio (V4L)

typically, /dev/radio?

MEDIA_INTF_T_V4L_SUBDEV Device node interface for a V4L subdevice

typically, /dev/v4l-subdev?

MEDIA_INTF_T_V4L_SWRADIO Device node interface for Software Defined Radio (V4L)

typically, /dev/swradio?

MEDIA_INTF_T_V4L_TOUCH Device node interface for Touch device (V4L)

typically, /dev/v4l-touch?

MEDIA_INTF_T_ALSA_PCM_CAPTURE Device node interface for ALSA PCM Capture

typically, /dev/snd/pcmC?D?c

MEDIA_INTF_T_ALSA_PCM_PLAYBACK Device node interface for ALSA PCM Playback

typically, /dev/snd/pcmC?D?p

MEDIA_INTF_T_ALSA_CONTROL Device node interface for ALSA Control

typically, /dev/snd/controlC?

MEDIA_INTF_T_ALSA_COMPRESS Device node interface for ALSA Compress

typically, /dev/snd/compr?

MEDIA_INTF_T_ALSA_RAWMIDI Device node interface for ALSA Raw MIDI

typically, /dev/snd/midi?

MEDIA_INTF_T_ALSA_HWDEP Device node interface for ALSA Hardware Dependent

typically, /dev/snd/hwC?D?

MEDIA_INTF_T_ALSA_SEQUENCER Device node interface for ALSA Sequencer

typically, /dev/snd/seq

MEDIA_INTF_T_ALSA_TIMER Device node interface for ALSA Timer

typically, /dev/snd/timer

Media pad flags
MEDIA_PAD_FL_SINK

Input pad, relative to the entity. Input pads sink data and are targets of links.

MEDIA_PAD_FL_SOURCE

Output pad, relative to the entity. Output pads source data and are origins of links.

MEDIA_PAD_FL_MUST_CONNECT

If this flag is set and the pad is linked to any other pad, then at least one of those links must be enabled for the entity to be able to stream. There could be temporary reasons (e.g. device configuration dependent) for the pad to need enabled links even when this flag isn’t set; the absence of the flag doesn’t imply there is none.

One and only one of MEDIA_PAD_FL_SINK and MEDIA_PAD_FL_SOURCE must be set for every pad.

Media link flags
MEDIA_LNK_FL_ENABLED

The link is enabled and can be used to transfer media data. When two or more links target a sink pad, only one of them can be enabled at a time.

MEDIA_LNK_FL_IMMUTABLE

The link enabled state can’t be modified at runtime. An immutable link is always enabled.

MEDIA_LNK_FL_DYNAMIC

The link enabled state can be modified during streaming. This flag is set by drivers and is read-only for applications.

MEDIA_LNK_FL_LINK_TYPE