Kernel driver adt7462¶
Analog Devices ADT7462
Addresses scanned: I2C 0x58, 0x5C
Datasheet: Publicly available at the Analog Devices website
Author: Darrick J. Wong
This driver implements support for the Analog Devices ADT7462 chip family.
This chip is a bit of a beast. It has 8 counters for measuring fan speed. It can also measure 13 voltages or 4 temperatures, or various combinations of the two. See the chip documentation for more details about the exact set of configurations. This driver does not allow one to configure the chip; that is left to the system designer.
A sophisticated control system for the PWM outputs is designed into the ADT7462 that allows fan speed to be adjusted automatically based on any of the three temperature sensors. Each PWM output is individually adjustable and programmable. Once configured, the ADT7462 will adjust the PWM outputs in response to the measured temperatures without further host intervention. This feature can also be disabled for manual control of the PWM’s.
Each of the measured inputs (voltage, temperature, fan speed) has corresponding high/low limit values. The ADT7462 will signal an ALARM if any measured value exceeds either limit.
The ADT7462 samples all inputs continuously. The driver will not read the registers more often than once every other second. Further, configuration data is only read once per minute.
The ADT7462 have a 10-bit ADC and can therefore measure temperatures with 0.25 degC resolution.
The Analog Devices datasheet is very detailed and describes a procedure for determining an optimal configuration for the automatic PWM control.
The driver will report sensor labels when it is able to determine that information from the configuration registers.
Besides standard interfaces driver adds the following:
pwm#_auto_point1_pwm and temp#_auto_point1_temp and
pwm#_auto_point2_pwm and temp#_auto_point2_temp -
point1: Set the pwm speed at a lower temperature bound.
point2: Set the pwm speed at a higher temperature bound.
The ADT7462 will scale the pwm between the lower and higher pwm speed when the temperature is between the two temperature boundaries. PWM values range from 0 (off) to 255 (full speed). Fan speed will be set to maximum when the temperature sensor associated with the PWM control exceeds temp#_max.