.. SPDX-License-Identifier: GPL-2.0-or-later Kernel driver max31760 ====================== Supported chips: * Analog Devices MAX31760 Prefix: 'max31760' Addresses scanned: none Datasheet: https://datasheets.maximintegrated.com/en/ds/MAX31760.pdf Author: Ibrahim Tilki Description ----------- The MAX31760 integrates temperature sensing along with precision PWM fan control. It accurately measures its local die temperature and the remote temperature of a discrete diode-connected transistor, such as a 2N3906, or a thermal diode commonly found on CPUs, graphics processor units (GPUs), and other ASICs. Multiple temperature thresholds, such as local high/overtemperature (OT) and remote high/overtemperature, can be set by an I2C-compatible interface. Fan speed is controlled based on the temperature reading as an index to a 48-byte lookup table (LUT) containing user-programmed PWM values. The flexible LUT-based architecture enables the user to program a smooth nonlinear fan speed vs. temperature transfer function to minimize acoustic fan noise. Two tachometer inputs allow measuring the speeds of two fans independently. When the local or remote OT threshold is exceeded, the SHDN pin is asserted low and can be used to shut down the system. A dedicated ALERT pin reports that either a local or remote high-temperature threshold has been exceeded. Temperature measurement range: from -55°C to 125°C Temperature Resolution: 11 Bits, ±0.125°C Please refer how to instantiate this driver: Documentation/i2c/instantiating-devices.rst Lookup table for auto fan control --------------------------------- ========= ================================= LUT Index Name ========= ================================= 1 PWM value for T < +18°C 2 PWM value for +18°C ≤ T < +20°C 3 PWM value for +20°C ≤ T < +22°C ... ... 47 PWM value for +108°C ≤ T < +110°C 48 PWM value for T ≥ +110°C ========= ================================= Sysfs entries ------------- =============================== ================================================================================= fan[1-2]_input Fan speed (in RPM) fan[1-2]_enable Enable fan readings and fan fault alarms fan[1-2]_fault Fan fault status temp[1-2]_label "Remote" and "Local" temperature channel labels temp[1-2]_input Temperature sensor readings (in millidegrees Celsius) temp1_fault Remote temperature sensor fault status temp[1-2]_max Temperature max value. Asserts "ALERT" pin when exceeded temp[1-2]_max_alarm Temperature max alarm status temp[1-2]_crit Temperature critical value. Asserts "SHDN" pin when exceeded temp[1-2]_crit_alarm Temperature critical alarm status pwm1 PWM value for direct fan control pwm1_enable 1: direct fan control, 2: temperature based auto fan control pwm1_freq PWM frequency in hertz pwm1_auto_channels_temp Temperature source for auto fan control. 1: temp1, 2: temp2, 3: max(temp1, temp2) pwm1_auto_point[1-48]_pwm PWM value for LUT point pwm1_auto_point_temp_hyst Temperature hysteresis for auto fan control. Can be either 2000mC or 4000mC =============================== =================================================================================