Flash LED handling under Linux ============================== Some LED devices provide two modes - torch and flash. In the LED subsystem those modes are supported by LED class (see Documentation/leds/leds-class.txt) and LED Flash class respectively. The torch mode related features are enabled by default and the flash ones only if a driver declares it by setting LED_DEV_CAP_FLASH flag. In order to enable the support for flash LEDs CONFIG_LEDS_CLASS_FLASH symbol must be defined in the kernel config. A LED Flash class driver must be registered in the LED subsystem with led_classdev_flash_register function. Following sysfs attributes are exposed for controlling flash LED devices: (see Documentation/ABI/testing/sysfs-class-led-flash) - flash_brightness - max_flash_brightness - flash_timeout - max_flash_timeout - flash_strobe - flash_fault V4L2 flash wrapper for flash LEDs ================================= A LED subsystem driver can be controlled also from the level of VideoForLinux2 subsystem. In order to enable this CONFIG_V4L2_FLASH_LED_CLASS symbol has to be defined in the kernel config. The driver must call the v4l2_flash_init function to get registered in the V4L2 subsystem. The function takes six arguments: - dev : flash device, e.g. an I2C device - of_node : of_node of the LED, may be NULL if the same as device's - fled_cdev : LED flash class device to wrap - iled_cdev : LED flash class device representing indicator LED associated with fled_cdev, may be NULL - ops : V4L2 specific ops * external_strobe_set - defines the source of the flash LED strobe - V4L2_CID_FLASH_STROBE control or external source, typically a sensor, which makes it possible to synchronise the flash strobe start with exposure start, * intensity_to_led_brightness and led_brightness_to_intensity - perform enum led_brightness <-> V4L2 intensity conversion in a device specific manner - they can be used for devices with non-linear LED current scale. - config : configuration for V4L2 Flash sub-device * dev_name - the name of the media entity, unique in the system, * flash_faults - bitmask of flash faults that the LED flash class device can report; corresponding LED_FAULT* bit definitions are available in , * torch_intensity - constraints for the LED in TORCH mode in microamperes, * indicator_intensity - constraints for the indicator LED in microamperes, * has_external_strobe - determines whether the flash strobe source can be switched to external, On remove the v4l2_flash_release function has to be called, which takes one argument - struct v4l2_flash pointer returned previously by v4l2_flash_init. This function can be safely called with NULL or error pointer argument. Please refer to drivers/leds/leds-max77693.c for an exemplary usage of the v4l2 flash wrapper. Once the V4L2 sub-device is registered by the driver which created the Media controller device, the sub-device node acts just as a node of a native V4L2 flash API device would. The calls are simply routed to the LED flash API. Opening the V4L2 flash sub-device makes the LED subsystem sysfs interface unavailable. The interface is re-enabled after the V4L2 flash sub-device is closed.