# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) %YAML 1.2 --- $id: http://devicetree.org/schemas/regulator/ti,tps62360.yaml# $schema: http://devicetree.org/meta-schemas/core.yaml# title: Texas Instruments TPS6236x Voltage Regulators maintainers: - Laxman Dewangan description: | The TPS6236x are a family of step down dc-dc converter with an input voltage range of 2.5V to 5.5V. The devices provide up to 3A peak load current, and an output voltage range of 0.77V to 1.4V (TPS62360/62) and 0.5V to 1.77V (TPS62361B/63). Datasheet is available at: https://www.ti.com/lit/gpn/tps62360 allOf: - $ref: regulator.yaml# properties: compatible: enum: - ti,tps62360 - ti,tps62361 - ti,tps62362 - ti,tps62363 reg: maxItems: 1 ti,vsel0-gpio: description: | GPIO for controlling VSEL0 line. If this property is missing, then assume that there is no GPIO for VSEL0 control. maxItems: 1 ti,vsel1-gpio: description: | GPIO for controlling VSEL1 line. If this property is missing, then assume that there is no GPIO for VSEL1 control. maxItems: 1 ti,enable-vout-discharge: description: Enable output discharge. type: boolean ti,enable-pull-down: description: Enable pull down. type: boolean ti,vsel0-state-high: description: | Initial state of VSEL0 input is high. If this property is missing, then assume the state as low. type: boolean ti,vsel1-state-high: description: | Initial state of VSEL1 input is high. If this property is missing, then assume the state as low. type: boolean required: - compatible - reg unevaluatedProperties: false examples: - | #include i2c { #address-cells = <1>; #size-cells = <0>; regulator@60 { compatible = "ti,tps62361"; reg = <0x60>; regulator-name = "tps62361-vout"; regulator-min-microvolt = <500000>; regulator-max-microvolt = <1500000>; regulator-boot-on; ti,vsel0-gpio = <&gpio1 16 GPIO_ACTIVE_HIGH>; ti,vsel1-gpio = <&gpio1 17 GPIO_ACTIVE_HIGH>; ti,vsel0-state-high; ti,vsel1-state-high; ti,enable-pull-down; ti,enable-vout-discharge; }; }; ...