* Chipselect/Local Bus Properties: - name : Should be localbus - #address-cells : Should be either two or three. The first cell is the chipselect number, and the remaining cells are the offset into the chipselect. - #size-cells : Either one or two, depending on how large each chipselect can be. - ranges : Each range corresponds to a single chipselect, and cover the entire access window as configured. Example: localbus@f0010100 { compatible = "fsl,mpc8272-localbus", "fsl,pq2-localbus"; #address-cells = <2>; #size-cells = <1>; reg = <0xf0010100 0x40>; ranges = <0x0 0x0 0xfe000000 0x02000000 0x1 0x0 0xf4500000 0x00008000 0x2 0x0 0xfd810000 0x00010000>; flash@0,0 { compatible = "jedec-flash"; reg = <0x0 0x0 0x2000000>; bank-width = <4>; device-width = <1>; }; board-control@1,0 { reg = <0x1 0x0 0x20>; compatible = "fsl,mpc8272ads-bcsr"; }; simple-periph@2,0 { compatible = "fsl,elbc-gpcm-uio"; reg = <0x2 0x0 0x10000>; elbc-gpcm-br = <0xfd810800>; elbc-gpcm-or = <0xffff09f7>; }; };