# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) %YAML 1.2 --- $id: http://devicetree.org/schemas/pinctrl/renesas,rzn1-pinctrl.yaml# $schema: http://devicetree.org/meta-schemas/core.yaml# title: Renesas RZ/N1 Pin Controller maintainers: - Fabrizio Castro - Geert Uytterhoeven properties: compatible: items: - enum: - renesas,r9a06g032-pinctrl # RZ/N1D - renesas,r9a06g033-pinctrl # RZ/N1S - const: renesas,rzn1-pinctrl # Generic RZ/N1 reg: items: - description: GPIO Multiplexing Level1 Register Block - description: GPIO Multiplexing Level2 Register Block clocks: maxItems: 1 clock-names: const: bus description: The bus clock, sometimes described as pclk, for register accesses. allOf: - $ref: pinctrl.yaml# required: - compatible - reg - clocks - clock-names additionalProperties: anyOf: - type: object allOf: - $ref: pincfg-node.yaml# - $ref: pinmux-node.yaml# description: A pin multiplexing sub-node describes how to configure a set of (or a single) pin in some desired alternate function mode. A single sub-node may define several pin configurations. properties: pinmux: description: | Integer array representing pin number and pin multiplexing configuration. When a pin has to be configured in alternate function mode, use this property to identify the pin by its global index, and provide its alternate function configuration number along with it. When multiple pins are required to be configured as part of the same alternate function they shall be specified as members of the same argument list of a single "pinmux" property. Integers values in the "pinmux" argument list are assembled as: (PIN | MUX_FUNC << 8) where PIN directly corresponds to the pl_gpio pin number and MUX_FUNC is one of the alternate function identifiers defined in: These identifiers collapse the IO Multiplex Configuration Level 1 and Level 2 numbers that are detailed in the hardware reference manual into a single number. The identifiers for Level 2 are simply offset by 10. Additional identifiers are provided to specify the MDIO source peripheral. bias-disable: true bias-pull-up: description: Pull up the pin with 50 kOhm bias-pull-down: description: Pull down the pin with 50 kOhm bias-high-impedance: true drive-strength: enum: [ 4, 6, 8, 12 ] required: - pinmux additionalProperties: $ref: "#/additionalProperties/anyOf/0" - type: object additionalProperties: $ref: "#/additionalProperties/anyOf/0" examples: - | #include #include pinctrl: pinctrl@40067000 { compatible = "renesas,r9a06g032-pinctrl", "renesas,rzn1-pinctrl"; reg = <0x40067000 0x1000>, <0x51000000 0x480>; clocks = <&sysctrl R9A06G032_HCLK_PINCONFIG>; clock-names = "bus"; /* * A serial communication interface with a TX output pin and an RX * input pin. */ pins_uart0: pins_uart0 { pinmux = < RZN1_PINMUX(103, RZN1_FUNC_UART0_I) /* UART0_TXD */ RZN1_PINMUX(104, RZN1_FUNC_UART0_I) /* UART0_RXD */ >; }; /* * Set the pull-up on the RXD pin of the UART. */ pins_uart0_alt: pins_uart0_alt { pinmux = ; pins_uart6_rx { pinmux = ; bias-pull-up; }; }; };