# SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause %YAML 1.2 --- $id: http://devicetree.org/schemas/input/touchscreen/goodix,gt9916.yaml# $schema: http://devicetree.org/meta-schemas/core.yaml# title: Goodix Berlin series touchscreen controller description: The Goodix Berlin series of touchscreen controllers be connected to either I2C or SPI buses. maintainers: - Neil Armstrong allOf: - $ref: touchscreen.yaml# - $ref: /schemas/spi/spi-peripheral-props.yaml# properties: compatible: enum: - goodix,gt9916 reg: maxItems: 1 interrupts: maxItems: 1 reset-gpios: maxItems: 1 avdd-supply: description: Analog power supply regulator on AVDD pin vddio-supply: description: power supply regulator on VDDIO pin spi-max-frequency: true touchscreen-inverted-x: true touchscreen-inverted-y: true touchscreen-size-x: true touchscreen-size-y: true touchscreen-swapped-x-y: true additionalProperties: false required: - compatible - reg - interrupts - avdd-supply - touchscreen-size-x - touchscreen-size-y examples: - | #include #include i2c { #address-cells = <1>; #size-cells = <0>; touchscreen@5d { compatible = "goodix,gt9916"; reg = <0x5d>; interrupt-parent = <&gpio>; interrupts = <25 IRQ_TYPE_LEVEL_LOW>; reset-gpios = <&gpio1 1 GPIO_ACTIVE_LOW>; avdd-supply = <&ts_avdd>; touchscreen-size-x = <1024>; touchscreen-size-y = <768>; }; }; - | #include #include spi { #address-cells = <1>; #size-cells = <0>; num-cs = <1>; cs-gpios = <&gpio 2 GPIO_ACTIVE_HIGH>; touchscreen@0 { compatible = "goodix,gt9916"; reg = <0>; interrupt-parent = <&gpio>; interrupts = <25 IRQ_TYPE_LEVEL_LOW>; reset-gpios = <&gpio1 1 GPIO_ACTIVE_LOW>; avdd-supply = <&ts_avdd>; spi-max-frequency = <1000000>; touchscreen-size-x = <1024>; touchscreen-size-y = <768>; }; }; ...