InvenSense MPU-6050 Six-Axis (Gyro + Accelerometer) MEMS MotionTracking Device http://www.invensense.com/mems/gyro/mpu6050.html Required properties: - compatible : should be one of "invensense,mpu6000" "invensense,mpu6050" "invensense,mpu6500" "invensense,mpu6515" "invensense,mpu9150" "invensense,mpu9250" "invensense,mpu9255" "invensense,icm20608" "invensense,icm20609" "invensense,icm20689" "invensense,icm20602" "invensense,icm20690" "invensense,iam20680" - reg : the I2C address of the sensor - interrupts: interrupt mapping for IRQ. It should be configured with flags IRQ_TYPE_LEVEL_HIGH, IRQ_TYPE_EDGE_RISING, IRQ_TYPE_LEVEL_LOW or IRQ_TYPE_EDGE_FALLING. Refer to interrupt-controller/interrupts.txt for generic interrupt client node bindings. Optional properties: - vdd-supply: regulator phandle for VDD supply - vddio-supply: regulator phandle for VDDIO supply - mount-matrix: an optional 3x3 mounting rotation matrix - i2c-gate node. These devices also support an auxiliary i2c bus. This is simple enough to be described using the i2c-gate binding. See i2c/i2c-gate.txt for more details. Example: mpu6050@68 { compatible = "invensense,mpu6050"; reg = <0x68>; interrupt-parent = <&gpio1>; interrupts = <18 IRQ_TYPE_EDGE_RISING>; mount-matrix = "-0.984807753012208", /* x0 */ "0", /* y0 */ "-0.173648177666930", /* z0 */ "0", /* x1 */ "-1", /* y1 */ "0", /* z1 */ "-0.173648177666930", /* x2 */ "0", /* y2 */ "0.984807753012208"; /* z2 */ }; mpu9250@68 { compatible = "invensense,mpu9250"; reg = <0x68>; interrupt-parent = <&gpio3>; interrupts = <21 IRQ_TYPE_LEVEL_HIGH>; i2c-gate { #address-cells = <1>; #size-cells = <0>; ax8975@c { compatible = "ak,ak8975"; reg = <0x0c>; }; }; };