NTC Thermistor hwmon sensors ------------------------------- Requires node properties: - "compatible" value : one of "epcos,b57330v2103" "epcos,b57891s0103" "murata,ncp15wb473" "murata,ncp18wb473" "murata,ncp21wb473" "murata,ncp03wb473" "murata,ncp15wl333" "murata,ncp03wf104" "murata,ncp15xh103" /* Usage of vendor name "ntc" is deprecated */ "ntc,ncp15wb473" "ntc,ncp18wb473" "ntc,ncp21wb473" "ntc,ncp03wb473" "ntc,ncp15wl333" - "pullup-uv" Pull up voltage in micro volts - "pullup-ohm" Pull up resistor value in ohms - "pulldown-ohm" Pull down resistor value in ohms - "connected-positive" Always ON, If not specified. Status change is possible. - "io-channels" Channel node of ADC to be used for conversion. Optional node properties: - "#thermal-sensor-cells" Used to expose itself to thermal fw. Read more about iio bindings at https://github.com/devicetree-org/dt-schema/blob/master/schemas/iio/ Example: ncp15wb473@0 { compatible = "murata,ncp15wb473"; pullup-uv = <1800000>; pullup-ohm = <47000>; pulldown-ohm = <0>; io-channels = <&adc 3>; };