# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) %YAML 1.2 --- $id: http://devicetree.org/schemas/gpio/nuvoton,sgpio.yaml# $schema: http://devicetree.org/meta-schemas/core.yaml# title: Nuvoton SGPIO controller maintainers: - Jim LIU description: | This SGPIO controller is for NUVOTON NPCM7xx and NPCM8xx SoC and detailed information is in the NPCM7XX/8XX SERIAL I/O EXPANSION INTERFACE section. Nuvoton NPCM7xx SGPIO module is combines a serial to parallel IC (HC595) and a parallel to serial IC (HC165). Clock is a division of the APB3 clock. This interface has 4 pins (D_out , D_in, S_CLK, LDSH). NPCM7xx/NPCM8xx have two sgpio modules. Each module can support up to 64 output pins, and up to 64 input pins, the pin is only for GPI or GPO. GPIO pins can be programmed to support the following options - Support interrupt option for each input port and various interrupt sensitivity options (level-high, level-low, edge-high, edge-low) - ngpios is number of nuvoton,input-ngpios GPIO lines and nuvoton,output-ngpios GPIO lines. nuvoton,input-ngpios GPIO lines is only for GPI. nuvoton,output-ngpios GPIO lines is only for GPO. properties: compatible: enum: - nuvoton,npcm750-sgpio - nuvoton,npcm845-sgpio reg: maxItems: 1 gpio-controller: true '#gpio-cells': const: 2 interrupts: maxItems: 1 clocks: maxItems: 1 nuvoton,input-ngpios: $ref: /schemas/types.yaml#/definitions/uint32 description: The numbers of GPIO's exposed. GPIO lines are only for GPI. minimum: 0 maximum: 64 nuvoton,output-ngpios: $ref: /schemas/types.yaml#/definitions/uint32 description: The numbers of GPIO's exposed. GPIO lines are only for GPO. minimum: 0 maximum: 64 required: - compatible - reg - gpio-controller - '#gpio-cells' - interrupts - nuvoton,input-ngpios - nuvoton,output-ngpios - clocks additionalProperties: false examples: - | #include #include gpio8: gpio@101000 { compatible = "nuvoton,npcm750-sgpio"; reg = <0x101000 0x200>; clocks = <&clk NPCM7XX_CLK_APB3>; interrupts = ; gpio-controller; #gpio-cells = <2>; nuvoton,input-ngpios = <64>; nuvoton,output-ngpios = <64>; };