# SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause %YAML 1.2 --- $id: http://devicetree.org/schemas/gpio/gpio-consumer-common.yaml# $schema: http://devicetree.org/meta-schemas/core.yaml# title: Common GPIO lines maintainers: - Bartosz Golaszewski - Linus Walleij description: Pay attention to using proper GPIO flag (e.g. GPIO_ACTIVE_LOW) for the GPIOs using inverted signal (e.g. RESETN). select: true properties: enable-gpios: maxItems: 1 description: GPIO connected to the enable control pin. reset-gpios: description: GPIO (or GPIOs for power sequence) connected to the device reset pin (e.g. RESET or RESETN). powerdown-gpios: maxItems: 1 description: GPIO connected to the power down pin (hardware power down or power cut, e.g. PD or PWDN). pwdn-gpios: maxItems: 1 description: Use powerdown-gpios deprecated: true wakeup-gpios: maxItems: 1 description: GPIO connected to the pin waking up the device from suspend or other power-saving modes. allOf: - if: properties: compatible: contains: enum: - mmc-pwrseq-simple then: properties: reset-gpios: minItems: 1 maxItems: 32 else: properties: reset-gpios: maxItems: 1 additionalProperties: true