* Clock bindings for Freescale i.MX6 Quad Required properties: - compatible: Should be "fsl,imx6q-ccm" - reg: Address and length of the register set - interrupts: Should contain CCM interrupt - #clock-cells: Should be <1> Optional properties: - fsl,pmic-stby-poweroff: Configure CCM to assert PMIC_STBY_REQ signal on power off. Use this property if the SoC should be powered off by external power management IC (PMIC) triggered via PMIC_STBY_REQ signal. Boards that are designed to initiate poweroff on PMIC_ON_REQ signal should be using "syscon-poweroff" driver instead. - clocks: list of clock specifiers, must contain an entry for each entry in clock-names - clock-names: valid names are "osc", "ckil", "ckih1", "anaclk1" and "anaclk2" The clock consumer should specify the desired clock by having the clock ID in its "clocks" phandle cell. See include/dt-bindings/clock/imx6qdl-clock.h for the full list of i.MX6 Quad and DualLite clock IDs. Examples: #include clks: ccm@20c4000 { compatible = "fsl,imx6q-ccm"; reg = <0x020c4000 0x4000>; interrupts = <0 87 0x04 0 88 0x04>; #clock-cells = <1>; }; uart1: serial@2020000 { compatible = "fsl,imx6q-uart", "fsl,imx21-uart"; reg = <0x02020000 0x4000>; interrupts = <0 26 0x04>; clocks = <&clks IMX6QDL_CLK_UART_IPG>, <&clks IMX6QDL_CLK_UART_SERIAL>; clock-names = "ipg", "per"; };