.. SPDX-License-Identifier: GPL-2.0 =========================== Subsystem Trace Points: PCI =========================== Overview ======== The PCI tracing system provides tracepoints to monitor critical hardware events that can impact system performance and reliability. These events normally show up here: /sys/kernel/tracing/events/pci Cf. include/trace/events/pci.h for the events definitions. Available Tracepoints ===================== pci_hp_event ------------ Monitors PCI hotplug events including card insertion/removal and link state changes. :: pci_hp_event "%s slot:%s, event:%s\n" **Event Types**: * ``LINK_UP`` - PCIe link established * ``LINK_DOWN`` - PCIe link lost * ``CARD_PRESENT`` - Card detected in slot * ``CARD_NOT_PRESENT`` - Card removed from slot **Example Usage**:: # Enable the tracepoint echo 1 > /sys/kernel/debug/tracing/events/pci/pci_hp_event/enable # Monitor events (the following output is generated when a device is hotplugged) cat /sys/kernel/debug/tracing/trace_pipe irq/51-pciehp-88 [001] ..... 1311.177459: pci_hp_event: 0000:00:02.0 slot:10, event:CARD_PRESENT irq/51-pciehp-88 [001] ..... 1311.177566: pci_hp_event: 0000:00:02.0 slot:10, event:LINK_UP pcie_link_event --------------- Monitors PCIe link speed changes and provides detailed link status information. :: pcie_link_event "%s type:%d, reason:%d, cur_bus_speed:%d, max_bus_speed:%d, width:%u, flit_mode:%u, status:%s\n" **Parameters**: * ``type`` - PCIe device type (4=Root Port, etc.) * ``reason`` - Reason for link change: - ``0`` - Link retrain - ``1`` - Bus enumeration - ``2`` - Bandwidth notification enable - ``3`` - Bandwidth notification IRQ - ``4`` - Hotplug event **Example Usage**:: # Enable the tracepoint echo 1 > /sys/kernel/debug/tracing/events/pci/pcie_link_event/enable # Monitor events (the following output is generated when a device is hotplugged) cat /sys/kernel/debug/tracing/trace_pipe irq/51-pciehp-88 [001] ..... 381.545386: pcie_link_event: 0000:00:02.0 type:4, reason:4, cur_bus_speed:20, max_bus_speed:23, width:1, flit_mode:0, status:DLLLA