Say Y or M if you want to add support for codecs attached to the Blackfin SPORT (synchronous serial ports) interface in I2S mode (supports single stereo In/Out). You will also need to select the audio interfaces to support below.
Say Y if you want to add support for SoC audio on BF527-EZKIT.
Say Y if you want to add support for AD73311 codec on Blackfin.
Enter the GPIO used to control AD73311's SE pin. Acceptable values are 0 to 7
Say Y or M if you want to add support for codecs attached to the Blackfin SPORT (synchronous serial ports) interface in TDM mode. You will also need to select the audio interfaces to support below.
Say Y if you want to add support for SoC audio on BF5xx STAMP/EZKIT.
Say Y if you want to add support for AD193X codec on Blackfin. This driver supports AD1936, AD1937, AD1938 and AD1939.
Say Y or M if you want to add support for codecs attached to the Blackfin SPORT (synchronous serial ports) interface in slot 16 mode (pseudo AC97 interface). You will also need to select the audio interfaces to support below. Note: AC97 codecs which do not implement the slot-16 mode will not function properly with this driver. This driver is known to work with the Analog Devices line of AC97 codecs.
Say y if you want AC97 driver to support mmap mode. We introduce an intermediate buffer to simulate mmap.
Say y if you want AC97 driver to support up to 5.1 channel audio. this mode will consume much more memory for DMA.
Set the correct GPIO for RESET the sound chip.
Say Y if you want to add support for SoC audio on BF5xx STAMP/EZKIT. Warning: Because Analog Devices Inc. discontinued the ad1980 sound chip since Sep. 2009, this ad1980 driver is not maintained, tested and supported by ADI now.
Set the correct SPORT for sound chip.