Say Y here if you want to connect 1-wire thermal sensors to your
wire.

Say Y here if you want to connect 1-wire
simple 64bit memory rom(ds2401/ds2411/ds1990*) to your wire.

Say Y here if you want to use a 1-wire

DS2408 8-Channel Addressable Switch device support

If you enable this you can read the counter values available
in the DS2423 chipset from the w1_slave file under the
sys file system.

Say Y here if you want to use a 1-wire
counter family device (DS2423).

Say Y here if you want to use a 1-wire
1kb EEPROM family device (DS2431)

Say Y here if you want to use a 1-wire
4kb EEPROM family device (DS2433).

Say Y here to protect DS2433 data with a CRC16.
Each block has 30 bytes of data and a two byte CRC16.
Full block writes are only allowed if the CRC is valid.

If you enable this you will have the DS2760 battery monitor
chip support.

The battery monitor chip is used in many batteries/devices
as the one who is responsible for charging/discharging/monitoring
Li+ batteries.

If you are unsure, say N.

If you enable this you will have the DS2780 battery monitor
chip support.

The battery monitor chip is used in many batteries/devices
as the one who is responsible for charging/discharging/monitoring
Li+ batteries.

If you are unsure, say N.

Say Y here if you want to use a hdq
bq27000 slave support.