Say Y here if you want to communicate with your 1-wire devices
using Matrox's G400 GPIO pins.

This support is also available as a module.  If so, the module
will be called matrox_w1.

Say Y here if you want to have a driver for DS2490 based USB <-> W1 bridges,
for example DS9490*.

This support is also available as a module.  If so, the module
will be called ds2490.

If you say yes here you get support for the Maxim DS2482
I2C to 1-Wire bridge.

This driver can also be built as a module.  If so, the module
will be called ds2482.

Say Y here to enable MXC 1-wire host

Say Y here to enable the DS1WM 1-wire driver, such as that
in HP iPAQ devices like h5xxx, h2200, and ASIC3-based like
hx4700.

Say Y here if you want to communicate with your 1-wire devices using
GPIO pins. This driver uses the GPIO API to control the wire.

This support is also available as a module.  If so, the module
will be called w1-gpio.

Say Y here if you want support for the 1-wire or HDQ Interface
on an OMAP processor.